Wet air oxidation is regarded as appropriate options for wastewater treatment with average organic compounds. The general purpose of this research is to determine the efficiency of three wet air oxidation methods, wet oxidation with hydrogen peroxide and absorption with activated carbon in removing organic matter and nitrogenous compounds from Isfahan's urban leachate. A leachate sample with the volume of 1.5 liters entered into a steel reactor with the volume of three liters and was put under a 10-bar pressure, at temperatures of 100, 200, and 300° as well as three retention times of 30, 60, and 90 minutes. The sample was placed at 18 stages of leachate storage ponds in Isfahan Compost Plant with the volume of 20 liters, using three WPO, WAO methods and a combination of WAO/GAC for leachate pre-treatment. Thirty percent of pure oxygen and hydrogen peroxide were applied as oxidation agents. The COD removal efficiency in WAO method is 7.8-33.3%, in BOD is 14.7-50.6%, the maximum removal percentage (efficiency) for NH₄-N is 53.3% and for NO₃-N is 56.4-73.9%. The removal efficiency of COD and BOD₅ is 4.6%-34 and 24%-50 respectively in WPO method. Adding GAC to the reactor, the removal efficiency of all parameters was improved. The maximum removal efficiency was increased 48% for COD, 31%-43.6 for BOD₅ by a combinational method, and the ratio of BOD₅/COD was also increased to 90%. In this paper, WAO and WPO process was used for Leachate pre-treatment and WAO/GAC combinational process was applied for improving the organic matter removal and leachate treatment; it was also determined that the recent process is much more efficient in removing resistant organic matter.

Enhanced treatment of ceramic-tile industry wastewater was investigated by modified coagulation–flocculation process using combination of poly-aluminum chloride (PAC) with anionic (A300), cationic polymer (C270) and nonionic polymers. The effects of pH, PAC coagulant dose alone and with polymers dose in various combinations was studied by jar tests. To compare the removal efficiencies of turbidity, total suspended solids (TSS), chemical oxygen demand (COD), and color at different levels, we run multivariate analysis of variance. Regarding the economic evaluation, we applied the incremental cost-effectiveness ratio. PAC had the best performance in pH 7 and in optimal dose of 400 mg/L; so that removal efficiency of wastewater turbidity, TSS, COD and color were 99.63%, 99.7%, 47.5% and 50.38%, respectively. The best removal efficiency for wastewater turbidity, TSS, COD and color were 99.87%, 99.89%, 87.5% and 93.02%, respectively which were obtained by combination of anionic polymer (1.5 mg/L) with PAC (300 mg/L). Furthermore, with combination of PAC + anionic + non-ionic polymers, the removal efficiency for wastewater turbidity, TSS, COD and color were 99.93%, 99.94%, 88% and 94.57%, respectively. The imposed cost for treating one cubic meter of ceramic-tile wastewater treatment by PAC + anionic and PAC + anionic and non-ionic polymers in comparison with PAC alone was reduced to 22.96% and therefore economically more affordable for the tile industry wastewater treatment.