In this paper, we design a polarization-independent and angle-insensitive broadband THz graphene metamaterial absorber based on the surface plasmon-polaritons resonance. Full-wave simulation is conducted, and the results show that the designed metamaterial absorber has an absorption above 99% in the frequency range from 1.23 THz to 1.68 THz, which refers to a very high standard. Furthermore, the absorber has the properties of tunability, and the absorption can be nearly adjusted from 1% to 99% by varying the Fermi energy level of the graphene from 0 eV to 0.7 eV. In the simulation, when the incident angles of TE and TM waves change from 0° to 60°, the average absorption keeps greater than 80%. The proposed absorber shows promising performance, which has potential applications in developing graphene-based terahertz energy harvesting and thermal emission.
In this paper, a metal-dielectric metamaterial absorber is proposed to achieve ultrabroadband absorption at frequencies from ultraviolet to near-infrared. Based on finite element method solutions, the average absorption of the absorber is 97.75% from 382 nm to 1100 nm, with a maximum of 99.92%, resulting from multiple resonance coupling. The influences of geometric parameters and incident conditions on absorption are investigated. Broadband and narrowband absorption changes are realized by changing incident light polarization. Polarization-independent properties can be realized by changing the dielectric structure to centrosymmetric. The average absorption of the polarization-independent structure is 97.11% from 250 nm to 1115 nm, with a maximum of 99.98%. The proposed absorber structure has wide optical applications including solar energy harvesting and light-emitting devices.
21 March 2019 in Journal of the Optical Society of America B
In this study, a surface plasmon resonance (SPR) biosensor based on graphene–barium titanate nanocomposites is optimized by using an Ag–Au bimetallic configuration to achieve sensitivity enhancement. The angular interrogation method is used for the analysis of the reflectance from the sensor. By optimizing parameters, a sensitivity and figure of merit as high as 294°/RIU and 42.13 1/RIU can be obtained with Ag–Au bimetallic film at a wavelength of 633 nm. Compared with conventional SPR biosensors with a single metal film, the sensitivity of the proposed biosensor with Ag–Au bimetallic film can be greatly enhanced. Also, Au thin film can be used as a protective layer to prevent oxidation of the Ag layer.
One-dimensional metal-oxides (1D-MO) nanostructure has been regarded as one of the most promising candidates for high-performance photodetectors due to their outstanding electronic properties, low-cost and environmental stability. However, the current bottlenecks are high energy consumption and relatively low sensitivity. Here, Schottky junctions between nanotubes (NTs) and FTO were fabricated by electrospinning SnO 2 NTs on FTO glass substrate, and the bias voltage of SnO 2 NTs photodetectors was as low as ∼1.76 V, which can effectively reduce energy consumption. Additionally, for improving the response and recovery speed of SnO 2 NTs photodetectors, the NTs were covered with organic/inorganic hybrid perovskite. SnO 2 NTs/perovskite heterostructure photodetectors exhibit fast response/recovery speed (∼0.075/0.04 s), and a wide optical response range (∼220–800 nm). At the same time, the bias voltage of heterostructure photodetectors was further reduced to 0.42 V. The outstanding performance is mainly attributed to the formation of type-II heterojunctions between SnO 2 NTs and perovskite, which can facilitate the separation of photogenerated carriers, as well as Schottky junction between SnO 2 NTs and FTO, which reduce the bias voltage. All the results indicate that the rational design of 1D-MO/perovskite heterostructure is a facile and efficient way to achieve high-performance photodetectors.