The use of solvent-impregnated resins (SIRs) as a hybrid technology between liquid extraction and adsorption was investigated for the enantioseparation of naproxen. A chiral recognition system from the enantioselective liquid–liquid extraction from the literature was taken as a starting point, comprising naproxen dissolved in an aqueous solution containing also the chiral selector hydroxypropyl-β-cyclodextrin (HP-β-CD) and an organic phase consisting of l-diisobutyl tartrate (l-IBT) dissolved in 1,2-dichloroethane. As a result of leaching of 1,2-dichloroethane, this solvent is unsuitable for use in a SIR and was replaced by 1-octanol. The effect of the concentrations of the chiral selectors on the equilibrium operational enantioselectivity was studied in the 1-octanol–water system. It was found that HP-β-CD strongly affected the operational selectivity but that l-IBT hardly affected the selectivity and could be omitted to reduce the complexity of the system. Enantioseparation of naproxen from aqueous systems using HP-β-CD as the selector with resin technology was investigated for both 1-octanol SIRs and nonimpregnated resins (NIRs) obtained using XAD4 resins. Both equilibrium capacities and uptake rates were studied, and it was found that the capacities were comparable in magnitude but that the uptake rates were remarkably much higher in the SIRs than in the NIRs. When applied in a packed bed, this will result in much shorter mass transfer zones and hence more effective use of the bed.
The development of bio-based plasticizers is increasingly important due to regulatory restrictions on several phthalates, growing concerns over plasticizer migration and toxicity, and the demand for renewable materials. In this work, eleven novel furfural-derived bio-based plasticizers were synthesized and evaluated in polylactic acid (PLA) at 15 wt% loading via melt compounding. Their influence on the thermomechanical properties of PLA was investigated, enabling the establishment of structure–property relationships. Hansen Solubility Parameters (HSPs) were used to predict plasticizer–PLA compatibility and correlate theoretical predictions with experimental performance. All developed bio-plasticizers exhibited onset degradation temperatures exceeding 225 °C, ensuring suitability for melt processing with PLA. Increasing the alkyl chain length in the diester bio-plasticizers reduced plasticization efficiency, consistent with lower predicted compatibility based on HSP analysis. The most promising candidates, namely 7-oxabicyclo[2.2.1]heptane-2,3-dicarboxylic acid 2,3-dihexyl ester (F/MA-C6), 7-oxabicyclo[2.2.1]heptane-2,3-dicarboxylic acid 2,3-dioctyl ester (F/MA-C8), and 1,1′-[oxybis(1-methyl-2,1-ethanediyl)]bistetrahydrofuroate (Bis-THF), substantially enhanced polymer chain mobility, reducing the glass transition temperature to approximately 28–35 °C compared to 60 °C for neat PLA. These bio-plasticizers also demonstrated outstanding plasticizing efficiency, achieving elongations at break exceeding 245%, compared with 4.5% for neat PLA. These results demonstrate that furfural-derived plasticizers are promising sustainable alternatives to conventional fossil-based plasticizers for flexible PLA applications.