Carbon fiber-reinforced polymer (CFRP) strengthening relies on effective load transfer across the bonded interface, yet the influence of adhesive layer thickness remains incompletely quantified. Twelve double-lap CFRP-to-steel joints with adhesive layer thicknesses of 0.5, 1.0, 1.5 and 2.0 mm were tested under displacement-controlled tension. CFRP strain measurements were used to determine interfacial shear stress distributions and local bond–slip responses. All specimens failed abruptly by mixed debonding at the CFRP–adhesive and steel–adhesive interfaces. Increasing the adhesive layer thickness from 0.5 to 2.0 mm reduced the mean ultimate load capacity from 126.24 to 79.42 kN. The mean nominal interfacial shear stress decreased from 8.42 to 5.29 MPa, and the fitted interfacial stiffness decreased by 45.4%. At higher load levels, shear stress concentrated near both bond ends and remained greater at the loaded end. The measured bond–slip curves showed no descending branch, consistent with the brittle response of the low-ductility adhesive. A thickness-dependent analytical model reduced the group-level mean absolute percentage error from 19.0% for the Xia & Teng model to 6.9%. It also reduced the root-mean-square error from 18.7 to 7.3 kN. Within the tested material system and thickness range, thinner adhesive layers therefore provided stiffer load transfer and higher ultimate load capacity.
28 September 2026 in The Baltic Journal of Road and Bridge Engineering
To investigate the effects of traffic-induced vibration on the shear performance and damage evolution of new-to-old concrete interfaces, eight groups of composite specimens with different curing ages were designed and fabricated, and a six-degree-of-freedom shaking table was used to simulate vehicle-induced vibration. Based on test results and acoustic-emission (AE) characteristics, a modified shear-capacity model incorporating vibration effects was established. In addition, the damage evolution of the interface was systematically revealed using an energy-based approach, RA-AF correlation analysis, and fuzzy C-means clustering. The results show that vibration applied during the early setting stage leads to an initial increase and subsequent decrease in interfacial shear capacity. The fuzzy C-means clustering. The results show that vibration applied during the early setting stage leads to an initial increase and subsequent decrease in interfacial shear capacity. The proposed modified model agrees well with the experimental measurements. According to the distribution of cumulative AE energy, the damage process can be divided into three stages: an elastic stage, a cracked-working stage, and a failure stage. Damage evolution is dominated by crack initiation and propagation at the interface and within the concrete matrix, which together account for more than 90% of the overall damage. The interfacial damage is primarily tensile in nature, with an event occurrence rate exceeding 75%, and the rise time of failure-related signals mainly falling within 0–200 μs.