The combination of two higher-order hybrid electromagnetic modes ( HEM 133 and HEM 123 ) in a simple cylindrical dielectric resonator is exploited in the presented letter to enhance antenna gain. Both modes were excited by the same feeding aperture in the ground plane of a microstrip line. A linearly polarized, broadside radiation pattern with maximum realized gain of about 11.6 dBi was successfully obtained. The antenna was designed for the ISM band with central frequency 5.8 GHz and relative bandwidth of at least 2.6%. For fabrication, we used a layered Arlon AR600 substrate of relative permittivity 6.15. Experimental results showed reasonable agreement with simulations and validated the new concept of the high-gain dielectric resonator antenna.
The Car2Car communication will use a reserved frequency band at 5.9 GHz. One of the key requirements for a Car2Car antenna is that the gain is concentrated in the horizontal plane, which is a problem due to the limited ground plane of a car roof. The influence of roof curvature, roof racks and panorama glass roofs were investigated to quantify them. To the authors knowledge such measurements have not been published yet. Three different antennas were simulated and measured on round ground planes and real car roofs in different configurations. The configuration with a panorama glass roof showed an unexpected high loss of gain in the direction of the glass roof in the range of 15 to 20 dB which result in a drastically reduced communication range to the front direction. This phenomenon is still under investigation.
Presented is the design of a planar lowpass filter with stubs separated by transmission lines. To minimise dimensions, the filter is completed by a fractal defected‐ground structure (DGS). The fractal DGS filter requires a 20% smaller substrate compared to a conventional filter with stubs.
6 November 2014 in IEEE Antennas and Wireless Propagation Letters
In this letter, we describe the design and simulation of on-body antennas for wireless body area network (WBAN) communication operating in the 61-GHz ISM frequency band. We developed a disc-like concept of an antenna. Instead of a direct connection between a circular disc and a feeding pin, the electromagnetic coupling is used. This concept enables us to obtain relatively broadband characteristics with omnidirectional radiation pattern and vertical polarization suitable for on-body communication. Impedance properties and radiation of the antenna were studied in open space and on a tissue-equivalent phantom representing the human body. Fabricated prototype is well matched from 59.3 to 63.4 GHz. The bandwidth of the antenna is about 7%. An antenna analyzed close to body tissue exhibits efficiency of at least 25% and the maximum gain 5.2 dB in the horizontal plane.
1 February 2016 in IET Microwaves, Antennas & Propagation
This study deals with a design procedure and achieved parameters of a microstrip patch antenna array fed by a substrate integrated waveguide (SIW) operating at V‐band. The antenna array consists of 6 × 8 microstrip patch antennas which are aperture coupled with an SIW‐based feeding network. The antenna design is performed in a full‐wave electromagnetic solver (ANSYS HFSS) for the operation frequency 60 GHz. The design procedure of the proposed antenna array comprises the analysis of an isolated radiating element, the synthesis of a linear array, and the development of an SIW‐based power divider. At the operation frequency 60 GHz, a fabricated prototype has an impedance bandwidth of 1.8% for a reflection coefficient lower than −10 dB, a gain of 21.6 dBi, and a low sidelobe level below −23 dB in the E‐plane and H‐plane.
1 June 2015 in IEEE Antennas and Wireless Propagation Letters
In this letter, a wideband semisolid skin-equivalent phantom with dielectric properties close to human skin in the V- and W-band is proposed. The constituents of the phantom are deionized water, agar, and gelatin powder. The phantom has been fabricated and validated by an open-ended waveguide method. Since it comprises low-cost constituents and its fabrication does not require special equipment, the phantom can be easily reproduced. The proposed skin-equivalent phantom can be used in the field of on-body antenna and propagation measurement at millimeter waves.