To face the challenges of fossil fuel shortage and stringent emission norms, there is growing interest in the potential usage of alternative fuels such as bio-ethanol and bio-butanol in internal combustion engines. More recently, Acetone–Butanol–Ethanol (ABE), the intermediate product of bio-butanol fermentation, has been gaining a lot of attention as an alternative fuel. The literature shows that the acetone in the ABE blends plays an important part in improving the combustion performance and emissions, owing to its higher volatility. Acetone and ethanol are the low-value byproducts during bio-butanol production, so using acetone and ethanol as fuel additives may have both economic and environmental benefits. This study focuses on the differences in combustion, performance and emission characteristics of a port-injection spark-ignition engine fueled with pure gasoline (G100), ethanol-containing gasoline (E10 and E30) and acetone-ethanol-gasoline blends (AE10 and AE30 at A:E volumetric ratio of 3:1). The tests were conducted at 1200 RPM, under gasoline maximum brake torque (MBT) at 3 bar and 5 bar brake mean effective pressure (BMEP). Performance and emission data were measured under various equivalence ratios. Based on the comparison of combustion phasing, brake thermal efficiency, brake specific fuel consumption and various emissions of different fuels, it was found that using acetone as an oxygenate additive with the default ECU calibration (for gasoline) maintained the thermal efficiency and showed lower unburned HC emissions.
1 September 2015 in Journal of Engineering for Gas Turbines and Power
Acetone–butanol–ethanol (ABE), as the intermediate product during producing biobutanol by fermentation, is considered as a promising alternative fuel due to its advanced properties and lower recovery cost. The spray and combustion process of ABE20 (20% ABE and 80% diesel) and pure diesel was investigated in a constant volume chamber. The tested ambient environments were set at different temperatures (1100 K, 900 K, and 700 K) and oxygen contents (21%, 16%, and 11%) to cover conventional combustion and low temperature combustion (LTC) conditions of diesel engines. The results show that with the addition of 20% ABE, blends exhibit an improved spray characteristics, shorter and narrower spray due to the low viscosity and high volatility of ABE components, and the spray performance impacted much less by environmental condition than that of neat diesel. In addition to the shorter spray penetration, ABE20 also exhibits a much longer flame lift-off length (FLoL) than that of neat diesel, which forms a much bigger gap from spray tip to flame area for ABE20 that will effectively reduce equivalence ratio of combustion region. As a result, the natural flame luminosity which represents the soot emission level of ABE20 is significantly lower than that of pure diesel (D100) at all tested conditions.