To promote the transition of microresonator dual-comb ranging (DCR) technology from the laboratory to practical applications, we have developed a DCR system based on two self-developed, self-starting silicon nitride (Si3N4) microcombs with repetition-rate-locking. By integrating servo-control circuits and employing an all-polarization-maintaining fiber design, we have achieved long-term stable operation of the system. To validate the system’s performance parameters, we conducted two verification experiments at the National Institute of Metrology, China (NIM): a comparison against the indoor national long-base comparator and a repeatability test at an outdoor field baseline. Over the indoor test range of 0–60 m, measurement results showed deviations within 6 μm when compared against the indoor national long-base comparator. At the outdoor field baseline location of 618 m, with a signal acquisition duration of 1 ms per measurement, the ranging standard deviation was 2.38 μm. During outdoor ranging experiments, the system operated continuously for over 4 h without the need for specialized thermal insulation or vibration isolation measures. These results demonstrate the exceptional measurement accuracy and stability of the microresonator DCR system.
Time and frequency standards constitute fundamental requirements for diverse applications spanning daily life technologies to advanced scientific research. Among precision time dissemination methods, microwave-clock-based dual comb time transfer has emerged as a promising approach that achieves ultra-precise time interval measurements through linear optical sampling. However, conventional peak detection methodologies employed in such systems exhibit critical limitations: vulnerability to amplitude noise interference and inherent accuracy constraints imposed by analog sampling rates. To address these challenges, we present a novel digital time differential measurement paradigm integrating three key algorithmic innovations: (1) adaptive signal detection and extraction protocols, (2) multi-stage noise suppression processing, and (3) optimized centroid determination techniques. This comprehensive digital processing framework significantly enhances both measurement stability and operational efficiency, demonstrating single-shot temporal resolution at 17.6 fs stability levels. Our method establishes new capabilities for high-precision time-frequency transfer applications requiring robust noise immunity and enhanced sampling dynamics.
A back-to-back time transfer system based on two integrated microcombs and linear optical sampling is demonstrated, establishing the feasibility of chip-scale microcomb sources for precision time–frequency metrology. Two microcombs with repetition rates near 20 GHz are built and repetition-rate locked before asynchronous heterodyne sampling. By tuning the initial optical-frequency offset between the two combs, the linear–optical–sampling signal is shifted into the bandwidth of low-frequency balanced photodetection and oscilloscope acquisition. In a dual-channel balanced-detection configuration, a time deviation of approximately 11 fs at an averaging time of 1 s is obtained. The results demonstrate coherent mapping of a microwave reference onto microcomb pulse trains and femtosecond-level readout of their relative timing, establishing the feasibility of integrated microcombs for precision time–frequency transfer.