Magnetic confinement fusion (MCF) based on neutral particle beam irradiation reached the highest gains with JET and is discussed in relation to the ITER project for a possible re-orientation with respect to the ignition process. Ignition plays a similar role for inertial confinement fusion (ICF). After a short review about specific ICF developments, the fast igniter development offered a re-consideration of igniting DT fuel at modest or low compression. The observation of extreme anomalies (Sauerbrey 1996, Zhanget al., 1998 and Badziaket al., 1999) at interaction of picosecond (ps) laser pulses above TW power could be explained as a skin layer mechanism based on earlier computations (Horaet al., 2002) with nonlinear (ponderomotive) force acceleration. The resulting very high ion current density space charge neutral plasma blocks interacting as pistons to ignite DT may lead to a new scheme of laser fusion with low cost energy generation.

The advent of ultra-high power lasers allows laser power levels that are about 1000 times the power of all the power stations in the USA. This opens the way to new approaches for inertial confinement fusions (ICF) that in turn can drastically reduce the laser input energy needed to achieve practical ICF power. The specific approach discussed here involves inducing a fusion burn wave by laser-driven impact of a relatively large block of plasma on the outside of a solid density fusion target. This new method is specifically selected to enable the extremely attractive, but demanding, neutron-free proton–B-11 fusion that potentially can lead to the long sought goal of an ultra “clean” fusion power plant.

Exceptionally high reaction gains of hydrogen protons measured with the boron isotope 11 are compared with other fusion reactions. This is leading to the conclusion that secondary avalanche reactions are happening and confirming the results of high-gain, neutron-free, clean, safe, low-cost, and long-term available energy. The essential basis is the unusual non-thermal block-ignition scheme with picosecond laser pulses of extremely high powers above the petawatt range.

Anomalous interaction of picosecond laser pulses of terawatt to petawatt power is due to suppression of relativistic self-focusing if prepulses are cut-off by a contrast ratio higher than 10⁸, resulting in quasi-neutral directed plasma blocks with deuterium tritium ion current densities above 10¹¹A/cm². This is still not high enough for ignition of solid-state density deuterium tritium because the energy flux densityE* has to be higher than the threshold of 4 ×10⁸J/cm²obtained within the theory of Chu (1972). A revision of this evaluation shows a reduction of this threshold by a factor 20 if the later discovered inhibition factors for thermal conduction because of double layer effects as well as the shorter stopping lengths of the alpha particles due to collective effects are taken into account. Under these relaxed conditions, the parameters of nonlinear force generated blocks of dielectrically increased thickness for deuterium tritium ignition with directed ions of energies near the 80 keV resonances are discussed.

Clusters of condensed deuterium of densities up to 10²⁹cm⁻³in pores in solid oxide crystals were confirmed from time-of-flight mass spectrometry measurements. Based on these facts, a schematic outline and possible conclusions of expectable generalizations are presented, which may lead to a simplification of laser driven fusion energy including new techniques for preparation of targets for application in experiments of the NIF type, but also for modified fast igniter experiments using proton or electron beams or side-on ignition of low compressed solid fusion fuel.

With the aim to overcome the problems of climatic changes and rising ocean levels, one option is to produce large-scale sustainable energy by nuclear fusion of hydrogen and other very light nuclei similar to the energy source of the sun. Sixty years of worldwide research for the ignition of the heavy hydrogen isotopes deuterium (D) and tritium (T) have come close to a breakthrough for ignition. The problem with the DT fusion is that generated neutrons are producing radioactive waste. One exception as the ideal clean fusion process – without neutron production – is the fusion of hydrogen (H) with the boron isotope¹¹B11 (B11). In this paper, we have mapped out our research based on recent experiments and simulations for a new energy source. We suggest how HB11 fusion for a reactor can be used instead of the DT option. We have mapped out our HB11 fusion in the following way: (i) The acceleration of a plasma block with a laser beam with the power and time duration of the order of 10 petawatts and one picosecond accordingly. (ii) A plasma confinement by a magnetic field of the order of a few kiloteslas created by a second laser beam with a pulse duration of a few nanoseconds (ns). (iii) The highly increased fusion of HB11 relative to present DT fusion is possible due to the alphas avalanche created in this process. (iv) The conversion of the output charged alpha particles directly to electricity. (v) To prove the above ideas, our simulations show for example that 14 milligram HB11 can produce 300 kWh energy if all achieved results are combined for the design of an absolutely clean power reactor producing low-cost energy.