In this study, we designed and fabricated a cable accommodating 4-core and 7-core multicore fibers (MCFs). Fiber characteristics including attenuation, dispersion and polarization mode dispersion (PMD) during the cabling procedure were measured and analyzed. We observed a significant degradation in PMD for MCFs, particularly for those outer cores proximate to the cladding. Thus it requires longer taps of MIMO equalizers to sufficiently equalize at the receiver for reliable communications at the subsea distance. To assess the PMD impact on outage performance with limitations of MIMO equalizers’ taps, we developed a C-band 8000-km submarine transmission model which was calibrated with measured parameters during cabling, for qualifying 4- and 7-core MCFs in practical use. Simulations performed on the calibrated model could predict the outage performance for ensuring the communication reliability. More than 2-dB SNR margin is required to prevent the PMD-induced outage with using 300-taps MIMO equalizer at the receiver. Based on these comprehensive tests and simulations, we emphasize the importance of carefully managing PMD and ensuring adequate system SNR margins during the practical cabling and deployment of optical MCFs submarine cables.
Smart cables extend submarine communication infrastructure toward marine environmental sensing and sensing-data backhaul. This paper investigates a multi-core fiber (MCF)-based prototype in which high-speed communication traffic and discrete-sensor data are routed through different spatial cores rather than sharing the same optical core. A 100 km weakly coupled four-core MCF was characterized and used as the central spatial-routing section, with two cores assigned to bidirectional communication and two cores to bidirectional sensing-data backhaul. At 1625 nm, the measured inter-core crosstalk (IC-XT) values for the four reported measurements were , , , and dB/100 km. The same MCF section was incorporated into repeatered and unrepeatered hybrid laboratory configurations, with additional single-mode-fiber spans extending the total link lengths to 500 km and 300 km, respectively. Under the tested 400 Gbps condition, no frame loss or system alarm was observed during 17 h of operation; the round-trip delay was approximately 2.35 ms and the packet jitter remained below . The sensing-node velocity channels recorded transient vibration responses and long-duration spectral distributions consistent with those of a reference CDS-E20 seismometer. These results support the feasibility of spatial-core routing for MCF-based smart cable prototypes.
Coupled-core multicore fiber (CC-MCF) transmissions rely on sufficient taps of multiple-input and multiple-output (MIMO) equalizers which should cover the channel temporal pulse response raised by the elevated spatial mode dispersion of fibers. Otherwise, the residual inter-core crosstalk (IC-XT) after MIMO will impede the signaling quality when employing finite taps of MIMO equalizers. In this study, we experimentally examine how residual IC-XT evolves by evaluating the covariance among MIMO-equalized spatial tributaries in multiple-span CC-MCF transmission links as the MIMO equalizers' tap length decreases. As indicated by results, increasing covariance values happen along with the stronger correlations among spatial modes after MIMO equalization with using shorter-tap equalizers. Multidimensional bit-wise decoding (MD-BWD) can process the spatial domain-constructed multidimensional symbols, offering adaptive decoding capability for the strongly-correlated spatial modes but introducing significant DSP computational complexity. To address this, we propose a sparse representation of log-likelihood ratio calculation in MD-BWD to minimize the reference labels needed for soft information acquisition during decoding procedure. Experimental results for optical 20-Gbaud DP-QPSK transmissions over 1500-km CC-4CFs show that the proposed multidimensional sparse decoding method reduces complexity by 96.5% compared to traditional MD-BWD, while maintaining Q factors below the 20% overhead FEC threshold using short-tap MIMO equalizers. This advancement in reducing DSP complexity could facilitate the practical implementation of MD-SD signaling to mitigate residual IC-XT issues.