The effect of the volume fraction of second-phase particles on the distribution of damaged particles and its relation to the tensile deformation behavior were investigated in the particle reinforced metal-matrix composites, Al-SiC. The spatial distributions of all SiC particles and the delaminated SiC particles were evaluated from their two-dimensional local number (LN2D). During tensile deformation, larger SiC particles in more highly clustered regions were more easily delaminated at the particle/matrix interface. The amount of particle delamination in the more highly clustered region increased with increasing volume fraction and strain during tensile deformation. A model was developed to explain the flow behavior of the composites; this showed a good fit to the experimental results in the presence of particle damage, especially when the spatial distribution of damaged particles was taken into consideration. [doi:10.2320/matertrans.MER2007237
16 February 2024 in Materials Science and Engineering: A
In this study, the fabrication of carbon containing aluminum composites was attempted by using low-pressure infiltration method. At first, porous preform containing vapor grown nano-fiber (VGCF) and pure aluminum powder was fabricated by spark plasma sintering (SPS) method. Porosity in preform was controlled by changing the applied pressure during plasma sintering. Consequently, the porous preform with 40-50vol% in porosity was obtained, which has enough compression strength for low-pressure infiltration (<1MPa). Then, the molten pure aluminum infiltrated to porous preform with 0.4MPa in applied pressure at 1023K, and consequently we can obtain the composite with 62-86% in density. The electrical and thermal conductivity of composites was affected by the porosity, strongly.
The Al–Si–Mg casting alloy was modified by strontium, and the microstructural classification of unmodified and Sr modified samples was accomplished by using our originally developed methods and machine learning techniques. The classification rates of unmodified and modified samples were at high levels and the highest rate reached 97.5% accuracy when using statistical data and the support vector machine as the classifier. The additive of Sr caused the distribution of eutectic-Si particles to change from a random distribution to a clustering arrangement, and decreased the particle size of eutectic-Si. The tensile properties of the alloy were significantly increased after modification due to the refinement of the eutectic-Si phase.