Hydrogen-based power-to-power (PTP) systems complement batteries for long-duration storage, but their assessment often assumes fixed electrolyzer and fuel-cell efficiencies. The main innovation of this work is developing a system-level methodology to quantify how component-model fidelity affects the annual assessment of photovoltaic-alkaline electrolyzer-hydrogen-proton exchange membrane fuel cell systems. To highlight parameter and operational differences, two approaches are compared for the Santa Cruz–Baltra case study. Case A relies on simplified parameter assumptions, using fixed AEL and PEMFC efficiencies of 0.65 and 0.52. In contrast, Case B resolves operational differences by capturing operating-point-dependent electrochemical behavior, part-load variations, and AEL thermal-state propagation. Both cases use identical system boundaries and supervisory control, allowing model-fidelity effects on hydrogen production, storage utilization, and electricity recovery to be quantified. Annual simulations show that Case A predicts higher recovered electricity than Case B. For a representative configuration, global efficiency decreases from 0.529 to 0.440 (a 17% relative difference). The largest relative difference in recovered electricity (~91%) occurs in constrained configurations. Component-level experimental validation does not constitute full system-level validation. Overall, operating-point-dependent models materially alter annual PTP performance estimates under variable renewable operation.
18 November 2025 in SolarPACES Conference Proceedings
This work presents a dynamic model of a novel Concentrated Solar Power plant that integrates Thermochemical Energy Storage with Calcium-Looping and a supercritical CO2 Brayton power block. The aim is to provide a simulation tool to assess annual plant performance under realistic solar conditions. The model was developed using the Modelica language and simulated with OpenModelica. The configuration includes a heliostat field with a Solar Multiple of 1.8, 4 hours of TCES storage, and a 100 MWe sCO2 Brayton cycle. The system effectively manages energy generation and storage through advanced control strategies, including defocusing to prevent overcharging and efficient handling of startup and shutdown phases. A parametric analysis was conducted to identify the optimal configuration, considering SM and storage hours variations. The results indicate that the highest plant efficiency and an LCOE below 110 USD/MWh are achieved with a solar multiple of approximately 2.6 and storage capacities exceeding 16 hours, aligning with ranges considered commercially viable for CSP technologies. However, the system exhibits higher radiation losses at the receiver due to the elevated reaction temperature. Despite this, the study demonstrates the energetic viability of the integrated CSP-TCES system. The findings highlight the potential of the proposed system, although ongoing efforts are aimed at further enhancing the model’s accuracy.
18 November 2026 in SolarPACES Conference Proceedings
The integration of thermochemical energy storage (TCES) based on calcium looping with supercritical CO₂ Brayton cycles offers a promising pathway to enhance the efficiency, dispatchability, and economic performance of solar power tower plants. This study evaluates five CO₂ storage line configurations in total: a baseline layout and four advanced alternatives including an external bypass, a turbine+preheater integration, and heat recovery via molten salt or thermal oil subsystems (which utilize internal bypass). A dynamic model developed in OpenModelica and Python was used to simulate dynamic operation under meteorological conditions from Carrera Pinto, Chile. Results show that bypasses prevent overcharging and improve flexibility, while expanders reduce parasitic compression losses. Heat recovery systems significantly reduce heater consumption and enhance net power output, with the thermal oil system achieving the highest capacity factor (65.1%) and largest reduction in energy losses (75.5%) relative to the baseline. Economic analysis indicates that the CO₂ line moderately impacts total plant cost (<12 MUSD), yet thermal oil and molten salt options achieve lower LCOE and LCOS, with the thermal oil configuration delivering a 50% improvement over the baseline. These results highlight the potential of optimized CO₂ line designs to improve the techno-economic viability of CSP plants and provide guidance for selecting high-performance, cost-effective storage configurations.