We compare the ion-induced electron emission from freestanding monolayers of graphene and to find a sixfold higher number of emitted electrons for graphene even though both materials have similar work functions. An effective single-band Hubbard model explains this finding by a charge-up in that prevents low energy electrons from escaping the surface within a period of a few femtoseconds after ion impact. We support these results by measuring the electron energy distribution for correlated pairs of electrons and transmitted ions. The majority of emitted primary electrons have an energy below 10 eV and are therefore subject to the dynamic charge-up effects at surfaces.
Pyroxenes ((Ca, Mg, Fe, Mn)2Si2O6) belong to the most abundant rock forming minerals that make up the surface of rocky planets and moons. Therefore, sputtering of pyroxenes by solar wind ions has to be considered as a very important process for modifying the surface of planetary bodies. This is increased due to potential sputtering by multiply charged ions; to quantify this effect, sputtering of wollastonite (CaSiO3) by He2+ ions was investigated. Thin films of CaSiO3 deposited on a quartz crystal microbalance were irradiated, allowing precise, in situ, real time sputtering yield measurements. Experimental results were compared with SDTrimSP simulations, which were improved by adapting the used input parameters. On freshly prepared surfaces, He2+ ions show a significant increase in sputtering, as compared to equally fast He+ ions. However, the yield decreases exponentially with fluence, reaching a lower steady state after sputtering of the first few monolayers. Experiments using Ar8+ ions show a similar behavior, which is qualitatively explained by a preferential depletion of surface oxygen due to potential sputtering. A corresponding quantitative model is applied, and the observed potential sputtering behaviors of both He and Ar are reproduced very well. The results of these calculations support the assumption that mainly O atoms are affected by potential sputtering. Based on our findings, we discuss the importance of potential sputtering for the solar wind eroding the lunar surface. Estimated concentration changes and sputtering yields are both in line with previous modeling for other materials, allowing a consistent perspective on the effects of solar wind potential sputtering.
The growing family of 2D materials led not long ago to combining different 2D layers and building artificial systems in the form of van-der-Waals heterostructures. Tailoring of heterostructure properties post-growth would greatly benefit from a modification technique with a monolayer precision. However, appropriate techniques for material modification with this precision are still missing. To achieve such control, slow highly charged ions appear ideal as they carry high amounts of potential energy, which is released rapidly upon ion neutralization at the position of the ion. The resulting potential energy deposition is thus limited to just a few atomic layers (in contrast to the kinetic energy deposition). Here, we irradiated a freestanding van-der-Waals MoS2/graphene heterostructure with 1.3 keV/amu xenon ions in high charge states of 38, which led to nm-sized pores that appear only in the MoS2 facing the ion beam, but not in graphene beneath the hole. Reversing the stacking order leaves both layers undamaged, which we attribute to the high conductivity and carrier mobility in graphene acting as a shield for the MoS2 underneath. Our main focus is here on monolayer MoS2, but we also analyzed areas with few-layer structures, and observed that the perforation is limited to the two topmost MoS2 layers, whereas deeper layers remain intact. Our results demonstrate that in addition to already being a valuable tool for materials processing, the usability of ion irradiation can be extended to mono(or bi-)layer manipulation of van-der-Waals heterostructures when also the localized potential energy deposition of highly charged ions is added to the toolbox.
5 August 2019 in The Journal of Physical Chemistry Letters
Over seventy years ago, Niels Bohr described how the charge state of an atomic ion moving through a solid changes dynamically as a result of electron capture and loss processes, eventually resulting in an equilibrium charge state. Although obvious, this process has so far eluded direct experimental observation. By peeling a solid, such as graphite, layer by layer, and studying the transmission of highly charged ions through single-, bi- and trilayer graphene, we can now observe dynamical changes in ion charge states with monolayer precision. In addition we present a first-principles approach based on the virtual photon model for interparticle energy transfer to corroborate our findings. Our model that uses a Gaussian shaped dynamic polarisability rather than a spatial delta function is a major step in providing a self-consistent description for interparticle de-excitation processes at the limit of small separations.
Charge exchange and kinetic energy loss of slow highly charged xenon ions transmitted through freestanding monolayer are studied. Two distinct exit charge state distributions, characterized by high and low charge states, are observed. They are accompanied by smaller and larger kinetic energy losses, as well as scattering angles, respectively. High charge exchange is attributed to two-center neutralization processes, which take place in close impact collisions with the target atoms. Experimental findings are compared to graphene as a target material and simulations based on a time-dependent scattering potential model. Independent of the target material, experimentally observed charge exchange can be modeled by the same electron capture and de-excitation rates for and graphene. A common dependence of the kinetic energy loss on the charge exchange for as well as graphene is also observed. Considering the similarities of the zero band-gap material graphene and the 1.9 eV band-gap material , we suggest that electron transport on the femtosecond timescale is dominated by the strong influence of the ion's Coulomb potential in contrast to the dispersion defined by the material's band structure.