An abdominal aortic aneurysm (AAA) is an enlargement of the abdominal aorta that can become a life-threatening disease. The pulsatile blood flow exhibits intricate laminar patterns in the abdominal portion of the human aorta under normal resting conditions, whereas secondary flows are caused by adjacent branches and abnormal vessel geometries. If a pathological disorder (e.g., aneurysm) alters the structural composition of the artery wall, the flow dynamics become more complex. In this study, we analyzed the hemodynamics of pulsatile blood flow in three-dimensional AAA models. Computational predictions of hemodynamic changes were performed considering idealized models for four severe proximal neck angulations of symmetric aneurysms assuming conditions of laminar flow and a rigid artery wall. The predictions were based on computational fluid dynamics throughout the cardiac cycle. Postprocessing was used to visualize the numerical findings. The hemodynamic changes in factors such as velocity, flow streamline, pressure, and wall shear stress were obtained and visualized. The resulting blood flow through the severely angulated proximal neck of the abdominal aorta caused strong turbulence and asymmetric flow inside the aneurysm sac, leading to blood recirculation, especially during diastole. The simulation results showed the formation of regions with high and low wall shear stress, turbulent flow, and recirculation in the aneurysm sac depending on the angulation, which could have led to aortic wall weakness.
14 September 2018 in Journal of Mechanical Science and Technology
Abdominal aortic aneurysm (AAA) is a dangerous disease and can cause sudden death if it ruptures. This study investigated blood flow behaviors and hemodynamic changes in three categories (small, medium and large diameters) of AAAs using computational fluid dynamics (CFD) based on patient geometry. Computed tomography images of patients with abdominal aortic aneurysms were used to construct a patient-specific AAA model. This study included one healthy subject and seven patients who had AAAs with a diameter larger than 3 cm. The results showed that the aortic aneurysms were highly turbulent in the diastolic phase, and there was an increase in turbulence as the aneurysm size increased. The time-averaged wall shear stress (TAWSS) in the artery was high at peak systole and decreased during diastole. The oscillating shear index (OSI) was higher at the middle and distal aortic aneurysm sac than in other areas. Low TAWSS and a high OSI in the aneurysm region may indicate a risk of wall rupture in AAA. This study suggests that CFD provides further insights by visualizing blood flow behaviors and quantitatively analyzing hemodynamic parameters.
15 August 2020 in Journal of Advanced Research in Fluid Mechanics and Thermal Sciences
This research aims to study the effect of pulsating frequency on flame structure and heat transfer characteristics of premixed flame from a pipe nozzle. The LPG and air were used as gas fuel and oxidizer. The equivalence ratios ( ) were evaluated at 0.8, 1.0, and 1.2 under a constant Reynolds number Re = 500. The effect of nozzle-to-impingement surface distance ratio was investigated at H = 2D to 10D, here D is the nozzle diameter at 12 mm. The frequency of pulsating (f) was varied from f = 0 to 10 Hz using a solenoid valve. The flame structures of free flame jet and the impinging flame jet were recorded with a digital camera. The average heat flux on impingement surface was measured with water cooling plate and evaluated from the heat balance of the cooling water. The results show that the pulsating of flame jet become having gap on flame and the mushroom appear at the end of flame. The size of mushroom structure becomes larger when increasing the frequency. While the non-pulsating jet did not appear in this structure. Pulsating flame jet can increase the overall average heat flux on the impingement surface up to about 12% for case of = 1.2 and H = 2D and f = 10 Hz. when compared to case of f = 0 Hz.