The aim of the present study is to remove dyes from aqueous solutions since the dye compounds are harmful to human life and the environment. Nano-zero-valent iron particles were synthesised and used to remove the synchronisation of Direct Red-31 (DR-31) and Direct Brown-2 (DB-2). Nano-zero-valent iron particles were characterised using SEM (scanning electron microscopy) and XRD (X-Ray Diffraction) analysis. The effects of five influential variables were investigated on the dye removal including DR-31 and DB-2 concentrations (4–20 mg L−1), NZVI dosage (0.15–0.95 g), pH of the solution (5–9) and contact time (20–140 s). In order to improve the conditions, the response surface methodology (RSM) approach was applied using the central composite design (CCD). The response for the removal of DR-31 and DB-2 was predicted second-order polynomial models. The Analysis of Variance (ANOVA) presented that second-order models, with high F-value, were so remarkable in order to eliminate the simultaneity of dyes. Based on the results of the perturbation plot, NZVI dosage and pH of the solution had the most effect on the removal of the dye mixture compared to three other factors. The optimum variables are achieved: NZVI dosage (0.75 g), DR-31 concentration (12.00 mg L−1), DB-2 concentration (12.00 mg L−1), contact time (110.00 s) and pH of the solution (6). Under optimal conditions, the removal rate of DR-31 and DB-2 was 91.03% and 94.57%, respectively. The NZVI can be used effectively to salvage pollution problems posed by anionic dyes in the environment.
Soil degradation due to erosion is a significant worldwide problem at different spatial (from pedon to watershed) and temporal scales. All stages and factors in the erosion process must be detected and evaluated to reduce this environmental issue and protect existing fertile soils and natural ecosystems. Laboratory studies using rainfall simulators allow single factors and interactive effects to be investigated under controlled conditions during extreme rainfall events. In this study, three main factors (rainfall intensity, inclination, and rainfall duration) were assessed to obtain empirical data for modeling water erosion during single rainfall events. Each factor was divided into three levels (− 1, 0, + 1), which were applied in different combinations using a rainfall simulator on beds (6 × 1 m) filled with soil from a study plot located in the arid Sistan region, Iran. The rainfall duration levels tested were 3, 5, and 7 min, the rainfall intensity levels were 30, 60, and 90 mm/h, and the inclination levels were 5, 15, and 25%. The results showed that the highest rainfall intensity tested (90 mm/h) for the longest duration (7 min) caused the highest runoff (62 mm3/s) and soil loss (1580 g/m2/h). Based on the empirical results, a quadratic function was the best mathematical model (R2 = 0.90) for predicting runoff (Q) and soil loss. Single-factor analysis revealed that rainfall intensity was more influential for runoff production than changes in time and inclination, while rainfall duration was the most influential single factor for soil loss. Modeling and three-dimensional depictions of the data revealed that sediment production was high and runoff production lower at the beginning of the experiment, but this trend was reversed over time as the soil became saturated. These results indicate that avoiding the initial stage of erosion is critical, so all soil protection measures should be taken to reduce the impact at this stage. The final stages of erosion appeared too complicated to be modeled, because different factors showed differing effects on erosion.
31 May 2018 in International Journal of Environmental Science and Technology