Investigating workplace exposure to mycotoxins is of the utmost importance in supporting the implementation of preventive measures for workers. The aim of this study was to provide tools for measuring mycotoxins in urine and airborne samples. A multi-class mycotoxin method was developed in urine for the determination of aflatoxin B1, aflatoxin M1, ochratoxin A, ochratoxin α, deoxynivalenol, zearalenone, α-zearalenol, β-zearalenol, fumonisin B1, HT2-toxin and T2-toxin. Analysis was based on liquid chromatography–high resolution mass spectrometry. Sample pre-treatments included enzymatic digestion and an online or offline sample clean-up step. The method was validated according to the European Medicines Agency guidance procedures. In order to estimate external exposure, air samples collected with a CIP 10 (Capteur Individuel de Particules 10) personal dust sampler were analyzed for the quantification of up to ten mycotoxins, including aflatoxins, ochratoxin A, deoxynivalenol, zearalenone, fumonisin B1 and HT-2 toxin and T-2 toxin. The method was validated according to standards for workplace exposure to chemical and biological agents EN 482. Both methods, biomonitoring and airborne mycotoxin measurement, showed good analytical performances. They were successfully applied in a small pilot study to assess mycotoxin contamination in workers during cleaning of a grain elevator. We demonstrated that this approach was suitable for investigating occupational exposure to mycotoxins.
It is now recognized that additional exposure to mycotoxins may occur through inhalation of contaminated dust at a workplace. The aim of this study was to characterize the multi-mycotoxin exposure of French grain elevator workers using biomonitoring and airborne measurements. Eighteen workers participated in the study. Personal airborne dust samples were analyzed for their mycotoxin concentrations. Workers provided multiple urine samples including pre-shift, post-shift and first morning urine samples or 24 h urine samples. Mycotoxin urinary biomarkers (aflatoxin B1, aflatoxin M1, ochratoxin A, ochratoxin α, deoxynivalenol, zearalenone, α-zearalenol, β-zearalenol, fumonisin B1, HT-2 toxin and T-2 toxin) were measured using a liquid chromatography–high-resolution mass spectrometry method. Grain elevator workers were highly exposed to organic airborne dust (median 4.92 mg.m−3). DON, ZEN and FB1 were frequent contaminants in 54, 76 and 72% of air samples, respectively. The mycotoxin biomarkers quantified were DON (98%), ZEN (99%), α-ZEL (52%), β-ZEL (33%), OTA (76%), T-2 (4%) and HT-2 (4%). DON elimination profiles showed highest concentrations in samples collected after the end of the work shift and the urinary DON concentrations were significantly higher in post-shift than in pre-shift-samples (9.9 and 22.1 µg/L, respectively). ZEN and its metabolites concentrations did not vary according to the sampling time. However, the levels of α-/β-ZEL were consistent with an additional occupational exposure. These data provide valuable information on grain worker exposure to mycotoxins. They also highlight the usefulness of multi-mycotoxin methods in assessing external and internal exposures, which shed light on the extent and pathways of exposure occurring in occupational settings.
Workers in the e-waste industry are exposed to chemical hazards, including organophosphate esters (OPEs) used as flame retardants (FRs). Assessing exposure through spot urine metabolite analysis is challenging due to limited knowledge of the toxicokinetics and urinary excretion patterns of OPEs. This pilot study investigates the temporal variability of seven organophosphate flame retardants (OPFRs) in urine samples from e-waste workers over five workdays to identify the most representative spot urine sample for accurately assessing occupational exposure. Six exposed workers provided urine samples from the first shift of the working week to the morning after the last workday. Seven metabolites, (bis(2-chloroethyl) phosphate (BCEP), diphenyl phosphate (DPHP), di-o-cresyl phosphate (DoCP), di-m-cresyl phosphate (DmCP), di-p-cresyl phosphate (DpCP), bis(1,3-dichloro-2-propyl) phosphate (BDCPP) and bis-(1-chloro-2-propyl) phosphate (BCPP)), were analyzed using liquid chromatography-mass spectrometry. DmCP + DpCP showed weekly increases and fair to good intraclass correlation coefficient (ICC), indicating moderate temporal variability across days. Conversely, DPHP and BCEP showed rapid decreases and lower ICC, suggesting higher intra-day variability. A grouping approach based on collection time and workday showed that the suitable spot urine is 2–5 h delayed post-shift for BCEP and DPHP, whereas the end of the workweek is the most appropriate time for DmCP + DpCP. This pilot study provides preliminary information on temporal variability to inform sampling design. This approach could be extended to a broader range of FRs, thereby enhancing the efficiency and accuracy of occupational biomonitoring.