The growing demand for environmentally sustainable enhanced oil recovery technologies has stimulated the development of alternative injection fluids. This study proposes and evaluates a novel biobased alkaline–surfactant–polymer (Bio-ASP) formulation composed of sodium carbonate, the biosurfactant surfactin, and the biopolymer xanthan gum, all derived from renewable resources. A full factorial 23 experimental design with three central replicates (11 core flooding experiments) was employed to investigate the individual and synergistic effects of these components on sandstone oil reservoirs. The Bio-ASP solutions were characterized in terms of the density, pH, interfacial tension, and viscosity. Results revealed that the surfactin concentration was the main factor in reducing interfacial tension, while xanthan gum primarily controlled viscosity and mobility, both significantly improving the oil recovery factor. The optimized Bio-ASP system achieved up to 63% tertiary oil recovery, outperforming conventional ASP systems reported in the literature. These findings highlight the novelty and technical viability of a fully biobased ASP system, offering a more sustainable and scalable alternative for efficient exploitation of mature or low-productivity reservoirs.
The rational design of environmentally friendly microemulsions for chemical enhanced oil recovery (EOR) remains a critical challenge, particularly in achieving interfacial efficiency and thermodynamic stability comparable to conventional petrochemical systems. In this study, we deconstruct the formulation puzzle by systematically comparing eight Winsor IV microemulsions composed of renewable and conventional components under reservoir-relevant conditions (60 °C). The systems were engineered using different combinations of nonpolar phases (toluene or pine oil), surfactants (Triton X-100 or saponified coconut oil), cosurfactants (isopropyl or ethyl alcohol), and polar phases (distilled water, saline brine, or glycerol), to reveal how molecular constituents cooperatively dictate phase architecture and physicochemical properties. Biobased formulations consistently produced significantly broader Winsor IV domains, up to 35% larger than their petrochemical analogues, while achieving low interfacial tensions (0.14–2.7 mN·m–1) and moderate viscosities (≤4.13 cP), effectively balancing injectivity with capillary desaturation potential. The synergistic pairing of saponified coconut oil with short-chain alcohols yielded flexible and resilient interfacial films, enabling enhanced performance across thermal and compositional gradients. For the first time, this work demonstrates that renewable surfactant–cosurfactant frameworks not only rival but, under the investigated thermal and salinity conditions, can surpass traditional hydrocarbon-based systems in interfacial behavior and formulation robustness, establishing a scalable and sustainable foundation for next-generation EOR applications.
Effective enhanced oil recovery (EOR) formulations should avoid compositional complexity. Biobased Winsor IV microemulsions were prepared using saponified coconut oil (surfactant), pine oil (nonpolar phase), isopropyl alcohol (cosurfactant), and either glycerol (MEG series) or aqueous 2% (w/v) NaCl (MES series) as the polar phase. Viscosity, conductivity, and oil–water interfacial tension (IFT) were measured at 60 °C. Displacement was evaluated in Botucatu sandstone plugs, using 2% (w/v) NaCl brine for core saturation and waterflooding. MEG3 and MES3, the highest-recovery formulations within their respective series, yielded recoveries of 79.1% and 77.4% of original oil in place (OOIP). With 100 ppm unfunctionalized SiO2, final recoveries were 77.4% and 75.2%, respectively. Incremental recovery as % OOIP was slightly higher in the SiO2 runs (27.4% and 26.8% vs. 26.7% and 26.2%), whereas residual-oil-normalized recovery efficiency was lower (54.8% and 51.9% vs. 56.1% and 53.7%). Each condition was tested once (n = 1) using separate plugs with different initial oil saturations. Thus, the comparison is descriptive and preliminary and establishes neither statistical differences nor equivalence. Because particle size, zeta potential, and colloidal stability were not characterized, the contribution of SiO2 to recovery remains undetermined.