The epoxidation of palm kernel oil-crude oleic acid was carried out to produce epoxidized oleic acid. Performic acid was formed by mixing formic acid (oxygen carrier) and hydrogen peroxide (oxygen donor) in various ratios of oleic acid, formic acid, and hydrogen peroxide. The signal-to-noise ratio and the analysis of variance are employed to investigate optimal conditions for the epoxidation based on Taguchi orthogonal array method. The optimum conditions based on two responses are the highest relative conversion to oxirane and stability occurred at moderate temperature of 55°C, agitation speed 200 rpm, molar ratio of formic acid:unsaturated oleic acid of 1:1 and molar ratio hydrogen peroxide:unsaturated oleic acid mole ratio of 1:1.5. In this study, the sulfuric acid was found to be the most efficient catalyst. Then, reaction rate for epoxidation of palm oleic acid was in the range of 0.0351–0.0941 min−1 calculated at various temperatures.
20 December 2022 in Journal of Elastomers & Plastics
In recent years, many efforts have been made to epoxidize palm oil in response to rising demand for environmentally safe epoxides that generated from vegetable oils. This experiment has studied two methods: the one-step method (continuous epoxidation-hydroxylation) and the two-step method (a separate process of epoxidation followed by hydroxylation) for bio-polyol production. Based on the results of the experiment, the one-step technique experiment was deemed to be the best approach because it did not require for the process to be stopped and because it is a continuous process, it takes less time to manufacture the bio-polyol and costs less because the catalyst is only used once. The relative conversion to oxirane (RCO) percentage was at its maximum (82%) after 30 min of epoxidation reaction. FTIR spectroscopy shows the absorption peak at a wavelength of 3300 cm−1 indicates the presence of hydroxyl groups when polyol was analyzed. Overall, a polyol with a high yield was successfully produced from palm oleic acid by using continuous hydroxylation of epoxidized oleic acid.
Epoxides were primarily derived from petroleum-based sources. However, there has been limited research on optimizing the process parameters for epoxidized palm oil-derived oleic acid, resulting in its underutilization. Therefore, this study aimed to optimize the catalytic epoxidation of palm oleic acid concerning the oxirane content by applying ion exchange resin as a catalyst. Epoxidized oleic acid was produced using in-situ-formed performic acid by combining formic acid as the oxygen carrier with hydrogen peroxide as the oxygen donor. The findings revealed that the optimal reaction conditions for producing epoxidized oleic acid with the highest oxirane content were an Amberlite IR-120 catalyst loading of 0.9 g, a molar ratio of formic acid to oleic acid of 1:1., and a molar ratio of hydrogen peroxide to oleic acid of 1:1.1. By employing these optimal conditions, the maximum relative conversion of palm oleic acid to oxirane was achieved at 85%. The reaction rate constants (k) based on the optimized epoxidized oleic acid are determined as follows: k11 = 20 mol L−1 min−1, k12 = 2 mol L−1 min−1, and k2 = 20 mol L−1 min−1. The findings validated the kinetic model by showing good agreement between the simulation and experimental data.