The present paper studied the effect of SiC particle size on microstructure and mechanical properties of Al5056/SiCp composite coatings. A wide powder size range varying from 2 to 67 μm assured the differences in the particle velocity and kinetic energy of the used SiC powders. Simulation results show that the velocity of SiC particle decreases with the increase of the particle size, while the kinetic energy greatly increases with the increase of particle size. The experimental microstructure observations show that the SiC content in the coatings decreases with the decrease of the SiC particle size under the bow shock effect due to the inferior kinetic energy. The microhardness of all the composite coatings is higher than that of the pure Al5056 coating, and the SiC powder in the coating could play a double face effect on the cohesion strength of the coatings.
In order to explore the main factors influencing the thermal conductivity of the cold sprayed Cu coating, four sets of Cu coatings with different deformation and annealing conditions were prepared by high/middle pressure cold spray systems followed by the annealing procedure. Microstructure and recrystallization analysis of the coatings were characterized by SEM and EBSD. Relationship of the thermal conductivity of the coating with the porosity and particle deformation was discussed. Results show that porosity is the main factor influencing the thermal conductivity of the Cu coating. The decrease in porosity by high pressure impacting of particles can improve the conductivity of the coating, while the annealing process can further decrease the porosity by increasing the annealing temperature and meanwhile eliminate the grain boundary by grain growth and recrystallization, which makes the annealing process an effective way to improve the conductivity of the cold sprayed Cu coating.
10 May 2021 in Journal of Thermal Spray Technology
Five hard-phase aluminium-based composite coating types with volume fractions of 12.5%, 25%, 37.5%, and 50%, respectively, were used. The addition of a large hard phase enhanced the coating densification. An increase in hard-phase content in the coating distributes more uniformly, but when the hard-phase content is too high, the hard phase is more likely to agglomerate, which decreases the distribution uniformity. Therefore, all those with a 25% volume fraction had the best uniformity. The kinetic energy of the hard-phase particles affects the distribution uniformity by changing the deposition method. When the kinetic energy is small, particles cannot be deposited effectively (Al 2 O 3 -8). When the kinetic energy is large, the metal-based plastic flows to form a fracture belt, which reduces the distribution uniformity (WC-72). When the kinetic energy does not cause the deposition method to change, the uniformity of the hard-phase distribution is similar.