Polyvinyl alcohol and pumice synthetized guar gum-nanoscale zerovalent iron beads (PPG-nZVI beads) were synthesized, and their adsorption towards Pb2+, Cu2+, and Zn2+ ions was evaluated. The adsorption kinetics of metal ions was well fitted by the pseudo-second-order model. The adsorption rate decreased followed in the order of Cu2+ > Pb2+ > Zn2+, consistent with the reduction potential of the ions. The sorption isotherm was well fitted by Langmuir model. The maximum adsorption capacity decreased followed in the order of Pb2+ > Cu2+ > Zn2+, which suggested that the strength of covalent bonds between the metal ions and surface functional groups substituted to the beads is one of the major factors in the adsorption process. Adsorption increased with the increase of pH and the largest sorption occurred at pH 5.5, while ionic strength did not significantly influence the adsorption process. The application of PPG-nZVI beads as filling materials in the simulated stormwater infiltration facility shows good removal efficiency in treating the contaminated water containing Pb2+, Cu2+, Zn2+, Cr6+, and Cd2+ and the removal rate was more than 65% at least. The results indicated that the PPG-nZVI beads could be applied as promising sorbents for purification of heavy metal contaminated water.
Heavy metals such as Cu(II), if ubiquitous in the runoff, can have adverse effects on the environment and human health. Lime sand bricks, as low-cost adsorbents to be potentially applied in stormwater infiltration facilities, were systematically investigated for Cu(II) removal from water using batch and column experiments. In the batch experiment, the adsorption of Cu(II) to bricks reach an equilibrium within 7 h and the kinetic data fits well with the pseudo-second-order model. The sorption isotherm can be described by both the Freundlich and Langmuir model and the maximum adsorption capacity of the bricks is 7 ± 1 mg/g. In the column experiment, the best removal efficiency for Cu(II) was observed at a filler thickness of 20 cm, service time of 12 min with a Cu(II) concentration of 0.5 mg/L. The Cu(II) removal rate increases with the increasing bed depth and residence time. The inlet concentration and residence time had significant effects on the Cu(II) removal analyzed by the Box–Behnken design (BBD). The Adams-Bohart model was in good agreement with the experimental data in representing the breakthrough curve. Copper fractions in the bricks descend in the order of organic matter fraction > Fe-Mn oxides fraction > carbonates fraction > residual fraction > exchangeable fraction, indicating that the lime sand bricks after copper adsorption reduce the long-term ecotoxicity and bioavailability to the environment.
The occurrence and ecological risks of 16 polycyclic aromatic hydrocarbons (PAHs) in different types of urban road runoff in Beijing during two typical rainfall events were studied. The average concentration of PAHs in road runoff particulate was in the order of Guanyuanqiao Road (ring road, 15,175 ng/L) > Huayuanqiao Road (primary road, 4,792 ng/L) > Dongcheng Alley (alley, 4,774 ng/L) > Nansihuan Viaduct (viaduct, 770 ng/L), much higher than dissolved PAHs. The total concentration of ∑16PAHs decreased with runoff scouring. Rainfall conditions and the accumulation of PAHs in the early rainfall period show a significant impact on PAHs pollution. The event mean concentration range of PAHs is 674–21,596 ng/L, following in the order of ring road > primary road > alley > viaduct. The proportion of four-ring PAHs was the highest. The first flush effect of PAHs is found in both rainfall events, and the effect of different ring PAHs is relatively similar. The content of PAHs is positively correlated with the amount of total organic carbon and suspended substance in runoff (r2> 0.72). The ecological risk assessment indicated that PAHs in road runoff except viaduct road corresponded to high risk.
8 September 2022 in Journal of Nanoparticle Research