Thanks to its high electrical conductivity, a graphene plane presents a good shielding efficiency against GHz electromagnetic radiations. Several graphene planes separated by thin polymer spacers add their conductivities arithmetically, because each of them conserves the intrinsic properties of isolated graphene. Maximum absorption of radiations for frequency around 30[emsp14]GHz is achieved with six separated graphene planes, which is the optimum number. This remarkable result is demonstrated experimentally from electromagnetic measurements performed in the Ka band on a series of multilayers obtained by piling 1, 2, 3 [mldr] graphene/PMMA units on a silica substrate. Theoretical calculations convincingly explain the observed absorption and transmission data in the GHz domain. It is concluded that graphene/PMMA multilayers can be used as an efficient optically transparent and flexible shielding media.

Experimental proof of localized plasmon resonance was found in thin films containing either single-walled carbon nanotubes (SWNT) or SWNT bundles of different length. All samples were prepared by a simple technique that permitted the selection of different SWNT lengths in different samples without significant differences in electronic properties. Fourier-transform infrared spectroscopy showed that an optical-density peak, the same as a terahertz conductivity peak, shifts to higher frequencies as the SWNT lengths are reduced—in agreement with a similar tendency predicted for the localized plasmon resonance in finite-length SWNTs [Slepyan et al., Phys. Rev. B 81, 205423 (2010)].

Fresnel equations predict that an ultrathin free standing conductive film, thousands times thinner than skin depth, is capable to absorb up to 50% of incident electromagnetic radiations. In the microwave range, the same holds true for a free standing graphene sheet. We demonstrate theoretically and prove experimentally that microwave absorptance of graphene can be enhanced considerably by depositing graphene on a dielectric substrate. On the experimental side, we obtain 80% and 65% absorptance at 30 GHz and 1 THz, respectively. Theory predicts that higher absorptance can be achieved with a suitable choice of the dielectric permittivity and the thickness of the substrate. Absorption can also be maximized by choosing the optimum incidence angle for s-polarized waves in free space or by working in the vicinity of the cut-off frequency of the transverse electric mode in waveguide configuration. The polarization sensitivity of the transmittance and reflectance of graphene layers can be used to tune the polarization state of the transmitted and reflected radiations.

A comprehensive analysis of electrical, electromagnetic (EM), mechanical, and thermal properties of epoxy resin composites filled with 0.25–2.0 wt. % of carbon additives characterized by high surface area, both nano-sized, like carbon nanotubes (CNTs) and carbon black (CBH), and micro-sized exfoliated graphite (EG), was performed. We found that the physical properties of both CNTs- and CBH-based epoxy resin composites increased all together with filler content and even more clearly for CBH than for CNTs. In the case of EG-based composites, good correlation between properties and filler amount was observed for concentrations below 1.5 wt. %. We conclude that CBH and, to a lower extent, EG could replace expensive CNTs for producing effective EM materials in microwave and low-frequency ranges, which are, in addition, mechanically and thermally stable.