Highly pure 1T MoS2 nanosheets were grown at 200 °C by a hydrothermal process. The effects of mild annealing on the structural and physical properties of the MoS2 were studied by heating the nanosheets in air and vacuum up to 350 °C. It was found that the annealing leads to an increase in resistivity for the nanosheets by 3 orders of magnitude, the appearance of two absorption bands in the visible range, and a hydrophilic to hydrophobic change in the surface wetting properties. Monitoring of the annealing process by Raman spectroscopy indicates that the material property changes are associated with a 1T to 2H MoS2 phase transition, with activation energies of 517 meV in air and 260 meV in vacuum. This study provides another way to control the electrical, optical, and surface properties of MoS2 nanosheets for fulfilling the needs of various applications.
29 April 2021 in Journal of Physics D: Applied Physics
Particle charging in the afterglows of non-thermal plasmas typically take place in a non-neutral space charge environment. We model the same by incorporating particle–ion collision rate constant models, developed in prior work by analyzing particle–ion trajectories calculated using Langevin Dynamics (LD) simulations, into species transport equations for ions, electrons and charged particles in the afterglow. A scaling analysis of particle charging and additional LD calculations of the particle–ion collision rate constant are presented to extend the range of applicability to ion electrostatic to thermal energy ratios of 300 and diffusive Knudsen number (that scales inversely with gas pressure) up to 2000. The developed collision rate constant models are first validated by comparing predictions of particle charge against measured values in a stationary, non-thermal DC plasma from past PK-4 campaigns published in Ratynskaia et al (2004 Phys. Rev. Lett. 93 085001) and Khrapak et al (2005 Phys. Rev. E 72 016406). The comparisons reveal excellent agreement within for particles of radius in the gas pressure range of . The experiments to probe particle charge distributions by Sharma et al (2020 J. Physics D: Appl. Phys. 53 245204) are modeled using the validated particle–ion collision rate constant models and the calculated charge fractions are compared with measurements. The comparisons reveal that the ion/electron concentration and gas temperature in the afterglow critically influence the particle charge and the predictions are generally in qualitative agreement with the measurements. Along with critical assessment of the modeling assumptions, several recommendations are presented for future experimental design to probe charging in afterglows.
As an emerging silicon-based two-dimensional (2D) material, vertical and horizontal Si2Te3 nanoplates on various substrates have been deposited by chemical vapor deposition. Structure, composition, and optical properties of these nanostructures are investigated by electron microscopy, x-ray photoelectron emission, energy dispersive x-ray spectroscopy, and temperature dependent photoluminescence. Band gap emissions of Si2Te3 nanoplates containing four noticeable emission peaks, i.e., free exciton, acceptor-bound exciton (A0X), and phonon replicas of A0X, are observed at temperatures below 90 K. The temperature dependent emission intensity of A0X indicates there are two quenching channels, which are associated with thermal quenching and thermal dissociations of A0X to free excitons. Two defect emissions are observed at measurement temperatures from 10 to 300 K, and their peak energies decrease by following the band gap change at low temperature range but increase at high temperature range as the temperature is increased. This abnormal temperature dependent behavior is explained by a combination of band gap shrinkage and thermally induced localization effects of defects at high temperature. This study helps to understand the electronic and optical properties of the unique 2D Si2Te3 nanostructures for potential applications.
Transparent conducting aluminum-doped zinc oxide (AZO) can be used as part of an active plasmonic device due to its electrically tunable permittivity, which is accomplished by changing the carrier concentration with electrical biasing. In this letter, we report a continuous electrical tuning of diffraction efficiency from AZO gratings in the visible range (specifically 532 nm) when the AZO is under bias voltages between −1 V and −3.5 V. The carrier concentration in AZO under negative bias has been measured and simulated. The diffraction efficiency changes have been explained by the carrier concentration variation and induced complex refractive index change at the Al2O3 and AZO interface. The reported results can lead toward the application of post-fabrication tuning of optoelectronic devices using AZO.