The use of an ultra-wideband (UWB) radio technique is proposed as a viable solution for the distribution of high-definition audio/video content in fiber-to-the-home (FTTH) networks. The approach suitability is demonstrated by the transmission of standards-based UWB signals at 1.25 Gb/s along different FTTH fiber links with 25 km up to 60 km of standard single-mode fiber length in a laboratory experiment. Experimental results suggest that orthogonal frequency-division-multiplexed UWB signals exhibit better transmission performance in FFTH networks than impulse radio UWB signals.

We propose and analyze a novel (to our knowledge) approach to implement the spectral self-imaging effect of optical frequency combs. The technique is based on time-domain multilevel phase-only modulation of a periodic optical pulse train. The method admits both infinite- and finite-duration periodic pulse sequences. We show that the fractional spectral self-imaging effect allows one to reduce by an integer factor the comb frequency spacing. Numerical simulation results support our theoretical analysis.

In this letter, we present a scalable high-speed W-band (75-110-GHz) fiber wireless communication system. By using an optical frequency comb generator, three-channel 8.3-Gb/s/ch optical orthogonal frequency-division-multiplexing (OOFDM) baseband signals in a 15-GHz bandwidth are seamlessly translated from the optical to the wireless domain. The W-band wireless carrier is generated from heterodyne mixing the OOFDM baseband signal with a free-running laser. A W-band electronic down-converter and a digital signal processing-based receiver are used. Three-channel QPSK-OFDM W-band wireless signals are transmitted over 0.5- and 2-m air distance with and without 22.8-km single-mode fiber, respectively, with achieved performance below the forward error correction limit.

This paper describes the state-of-the-art of polarization multiplexing for optical networks transmission. The use of polarization division multiplexing (PDM) permits to multiply the user capacity and increase the spectral efficiency. Combining PDM and orthogonal frequency division multiplexed (OFDM) modulation allows maximizing the optical transmission capacity. The experimental demonstration of transmitting OFDM signals following ECMA-368 ultrawide band (UWB) standard in radio-over-fiber using PDM in passive optical networks is herein reported. The impact of cross-polarization and cochannel crosstalk is evaluated experimentally in a three-user OFDM-UWB subcarrier multiplexed (SCM) configuration per polarization. Each SCM uses up to three OFDM-UWB channels of 200 Mbit/s each, achieving an aggregated bitrate of 1.2 Gbit/s with 0.76 bit/s/Hz spectral efficiency when using PDM transmission. The experimental results for the polarization-multiplexed SCM indicate that a 4 dB additional polarization crosstalk interference can be expected compared to a nonpolarization-multiplexed transmission system which translates to 2.4 dB EVM penalty in the UWB signals. The successful PDM transmission of SCM multiuser OFDM-UWB over a passive optical network of 25 km standard-single mode fiber (SSMF) reach is demonstrated.

We propose and demonstrate a 25-Gb/s 16-quadrature amplitude modulation orthogonal frequency division multiplexing 60-GHz radio over fiber transmission system based on a gain-switched optical comb source. The impact of the phase noise caused by the optical phase decorrelation due to the chromatic dispersion is theoretically studied and experimentally investigated by employing a high linewidth comb source and transmitting over a 50-km standard single-mode fiber reel. A time delay precompensation is deployed based on the study of phase noise in order to reduce the phase noise impact, and thereby improve system performance.