A compilation of data for small molecule organic, polymeric, and inorganic glass-forming liquids shows that the original expectation, that there be a positive correlation between the thermodynamic measure of fragility (or and the dynamic fragility index m, is not generally true. The results are consistent with three classes of behavior: (1) a decrease in m with increasing for the polymeric glass formers; (2) a nearly constant value of m independent of for small molecule organics and hydrogen bonding small molecules; (3) an increasing value of m with increasing for inorganic glass formers as originally considered by Angell.
The dynamic fragilities of six polymeric materials have been compared for isobaric (constant pressure) and isochoric (constant volume) conditions. Data were taken from the published literature for dynamic experiments performed at elevated pressures. Published pressure–volume–temperature data were then used to determine the dynamic response as a function of temperature for both the isochoric and isobaric conditions. It is found that the pressure and volume dependences of the dynamic fragility vary greatly among the polymers for which data were available. For poly(vinyl acetate) (PVAc) and poly(ethyl acrylate) (PEA), the dynamic fragility is independent of the pressure and specific volume and the isochoric and isobaric fragilities are almost the same. On the other hand for poly(vinylchloride) (PVC), polystyrene (PS) and poly(methyl acrylate) (PMA), the dynamic fragility is sensitive to changes of pressure and volume and the isobaric behavior is more fragile than the isochoric behavior when referenced to the same glass formation points It is also remarked that the signature Vogel–Fulcher temperature dependence of the isobaric dynamics is lost for the isochoric behavior of both PMA and PVC.
The specific heat capacity was measured with step-scan differential scanning calorimetry for linear alkanes from pentane to nonadecane , for several cyclic alkanes, for linear and cyclic polyethylenes, and for a linear and a cyclic polystyrene. For the linear alkanes, the specific heat capacity in the equilibrium liquid state decreases as chain length increases; above a carbon number of 10 (decane) the specific heat asymptotes to a constant value. For the cyclic alkanes, the heat capacity in the equilibrium liquid state is lower than that of the corresponding linear chains and increases with increasing chain length. At high enough molecular weights, the heat capacities of cyclic and linear molecules are expected to be equal, and this is found to be the case for the polyethylenes and polystyrenes studied. In addition, the thermal properties of the solid-liquid and the solid-solid transitions are examined for the linear and cyclic alkanes; solid-solid transitions are observed only in the odd-numbered alkanes. The thermal expansion coefficients and the specific volumes of the linear and cyclic alkanes are also calculated from literature data and compared with the trends in the specific heats.