The Puyo-Tena roadway is prone to landslides due to the geodynamics, geomorphology, and geological materials of the area (unstable outcrops and strata). In recent years, this problem has persistently caused the road to be partially or completely disabled on numerous occasions. The objective of the research was to generate a cartographic model of landslides susceptibility based on variables such as slope, geological formations, land cover and land use, as well as distances to faults, road, and rivers. The degree of landslides incidence was estimated as the linear combination of the weighted variables using the analytic hierarchy process. The importance of this semi quantitative method lies in its ability to break down a complex decision problem into a simpler and more coherent decision model. The resulting cartographic model was classified into five susceptibility categories: very low, low, moderate, high, and very high. The results showed that 17 km out of the 80 km of the Puyo-Tena roadway have a high probability of landslides, which is equivalent to 21.25% of the road. Furthermore, within this percentage, it was determined that there are fifteen regions with a high probability of landslides due to their location in areas with steep slopes, porous and permeable lithology, a large number of rivers, and agricultural soils. The area under the curve (AUC) of the receiver operating characteristic (ROC) was used for model verification. The verification results showed that the cartographic model for the study area has an accuracy value of 83.7%. The cartographic model of landslide susceptibility will enable relevant decisions to be made to mitigate potential hazards that may endanger transporters, material goods, and residents of the area.
Como requisito previo para la consecución de imágenes tomográficas se estudian tres modelos de Moho. Para la región de Ecuador se analizan el modelo gravimétrico de Chambat-Valette, un modelo de velocidades de propagación de ondas sísmicas en tres dimensiones y un modelo de observaciones gravimétricas satelitales. Se presenta como resultado un modelo que junta las mejores características de estas tres investigaciones previas.
5 November 2021 in Periodica Polytechnica Civil Engineering
Roads are generally affected by slope failures, and these failures can increase when there are weathered materials and high rainfall. These circumstances occur in the sub-Andean zone of Ecuador. This is the region where the study area is located. The stability of a stratified rock slope, which is affecting a section of highway E45, was evaluated. The study slope is exposed to the road, but the upper part is covered by a soil-type material and dense vegetation that makes it challenging to study. We applied the Q-slope method and seismic tomography; these methods used together worked well, because they allowed to correlate and infer information about the quality of the rock mass, even in a fast and economical way. We also performed core drilling with core recovery in the crown of the slope and SPT test. The slope presented two well-differentiated zones; therefore, Q-slope values were calculated for each of these zones. The results show that the slope is unstable. The application of seismic tomography as an input parameter for calculating Q-slope was important because it allowed evaluating the stability where it is impossible to collect geomechanical information, correlate information taken at the foot of the slope, and define the depth of the bedrock.
The Abitagua Batholith is a Mid to Late Jurassic intrusive body in the Sub-Andean Zone of Ecuador. This batholith is theorized to be the source of alluvial gold in the Amazon rivers that drain from it, although due to its difficult access and location along protected areas it remains largely unexplored. This work aims to study the Abitagua Batholith using seismic velocity models that provide absolute and relative P-wave velocity and Vp/Vs ratios based on the inversion of the earthquake travel-time data recorded by the Ecuadorian survey networks RENSIG, RENAC, and ROVIG, and some stations of the Colombian Geological Service near the border with Ecuador. We use the absolute and relative P-wave velocity tomography models to describe the batholith’s vertical and horizontal components. The resolution in our velocity models displays values larger than 0.8 and cover all the crust and the upper mantle to depths of seventy kilometers. We identify two velocity anomalies, possibly associated with magmatic reservoirs under the batholith that, together with hypocenter data, suggest more recent magma intrusions. We conclude that these magmatic bodies relate to potential gold-bearing intrusions, which seem to concentrate near the transition zone between the negative and positive velocity anomalies, five kilometers north of the Jatunyaku River.