We report here electrochemical capacitors using an aqueous electrolyte based on the concept of “water-in-salt” with the aim to improve the energy density by increasing the voltage of the cell. A “water-in-salt” consists of a highly concentrated aqueous LiTFSI solution in which both volume and mass of LiTFSI are greater than those of water. With activated carbon supercapacitor electrodes (PICA) and 31 m “water-in-salt” electrolytes (m stands for molality), we were able to reach a cell voltage of 2.4 V whereas it is difficult to exceed 1.6 V in conventional aqueous devices because of water splitting. Moreover, it was observed that the specific capacitance of the cell is improved using “water-in-salt” electrolytes. In these conditions, an energy density of 30 Wh kg−1 was obtained which is at least three times greater than for conventional aqueous devices and in the same order of magnitude than for redox enhanced capacitors. Interestingly, fair stability, over 2000 cycles, was obtained for the 7 m electrolyte. Up to 90 sec charging-discharging rate, this latter electrolyte offers the best compromise between voltage, power and energy densities and stability. This study demonstrates the feasibility of water-in-salt as an electrolyte for supercapacitors and points out the most suited compositions for these electrolytes.
4 January 2021 in Journal of Materials Chemistry A
In this paper, we grew the vanadium-doped nickel nitride porous nanosheet arrays supported on NF, V-Ni3N/NF, which displays efficient catalytic performance for urea electrolysis with energy-saving H2production.
In recent decades, more than 100,000 scientific articles have been devoted to the development of electrode materials for supercapacitors and batteries. However, there is still intense debate surrounding the criteria for determining the electrochemical behavior involved in Faradaic reactions, as the issue is often complicated by the electrochemical signals produced by various electrode materials and their different physicochemical properties. The difficulty lies in the inability to determine which electrode type (battery vs. pseudocapacitor) these materials belong to via simple binary classification. To overcome this difficulty, we apply supervised machine learning for image classification to electrochemical shape analysis (over 5500 Cyclic Voltammetry curves and 2900 Galvanostatic Charge-Discharge curves), with the predicted confidence percentage reflecting the shape trend of the curve and thus defined as a manufacturer. It’s called “capacitive tendency”. This predictor not only transcends the limitations of human-based classification but also provides statistical trends regarding electrochemical behavior. Of note, and of particular importance to the electrochemical energy storage community, which publishes over a hundred articles per week, we have created an online tool to easily categorize their data.
10 May 2020 in Angewandte Chemie International Edition
Water‐in‐salt electrolytes based on highly concentrated bis(trifluoromethyl)sulfonimide (TFSI) promise aqueous electrolytes with stabilities nearing 3 V. However, especially with an electrode approaching the cathodic (reductive) stability, cycling stability is insufficient. While stability critically relies on a solid electrolyte interphase (SEI), the mechanism behind the cathodic stability limit remains unclear. Now, two distinct reduction potentials are revealed for the chemical environments of free and bound water and that both contribute to SEI formation. Free water is reduced about 1 V above bound water in a hydrogen evolution reaction (HER) and is responsible for SEI formation via reactive intermediates of the HER; concurrent LiTFSI precipitation/dissolution establishes a dynamic interface. The free‐water population emerges, therefore, as the handle to extend the cathodic limit of aqueous electrolytes and the battery cycling stability.