Mario de Vicente Peño

Dr. Mario de Vicente Peño

DACSON, Universidad Politécnica, Madrid, Spain
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 May 2022 in Journal of Marine Science and Technology
Verified
Journal Article
Open access
PDF file
Mario de Vicente PeñoMario de Vicente Peño
Mario de Vicente Peño
ASArturo Silva-Campillo
Arturo Silva-Campillo
MHMiguel Ángel Herreros
Miguel Ángel Herreros
JSJuan Carlos Suárez-Bermejo
Juan Carlos Suárez-Bermejo
Shipbuilding with steel elements has changed little over the past 100 years. The introduction of hybrid materials has led to certain changes in construction methodology and in the calculation of structure and fabrication in shipyards. This study assesses a welded/adhesively joint used as a primary element union. It is made of steel and is used with a hybrid panel that is easy to manufacture and install at a low cost. To define the geometry of the joint, topological optimization of a symmetrical clamp-shaped steel part is carried out, attaching the hybrid panel with a structural adhesive. The geometric shape resulting from this optimization is analysed with a finite element model by means of a non-linear cohesive zone model simulation, minimizing the Von Mises stresses. The numerical result is compared to a destructive laboratory test. The result is analysed using the digital image correlation technique, making the following validations: in the adhesive-bonded area, no damage was found; the structural failure begins in the area near the embedded end; and there is an absence of cracks since no debonding of the structural adhesive takes place, confirming the obtained design by numerical simulation.

Verified
Journal Article
Open access
PDF file
Mario de Vicente PeñoMario de Vicente Peño
Mario de Vicente Peño
ASArturo Silva-Campillo
Arturo Silva-Campillo
MGMIGUEL JESUS TABOADA GOSALVEZ
MIGUEL JESUS TABOADA GOSALVEZ
AAAlbert Monclus Abadal
Albert Monclus Abadal
SASergi Ametller
Sergi Ametller
This study compares time-domain and frequency-domain fatigue assessment methodologies for the HiveWind semi-submersible floating offshore wind turbine (FOWT). Identical structural regions were selected from a global fatigue screening covering more than 16,000 hot spots. The time-domain approach combines Bladed–OrcaFlex coupled simulations with a high-fidelity Reduced Basis Finite Element Method (RB-FEM) structural model, whereas the frequency-domain approach combines linear wave-induced structural transfer functions with damage-equivalent turbine loads. The two approaches were compared at three representative structural details located at different positions within the floater. The results show a strong dependence of the agreement on structural location: the largest discrepancies occur at the central column–bracing connection, close to the wind-turbine load path, whereas substantially better agreement is obtained at a more distant column and in the heave-plate regions. The frequency-domain methodology requires substantially fewer computational resources, but its underlying linearization and DEL representation do not retain load sequence, relative phase, transient peaks, or nonlinear coupling effects. These results support a location-dependent assessment strategy in which detailed time-domain analyses are concentrated on fatigue-critical regions, while frequency-domain methods are used for preliminary assessment and less dynamically sensitive locations.