The spectral range of solar radiation observed on the earth is approximately 295 to 2500 nm. How to widen the absorption band of the plasmonic absorber in this range has become a hot issue in recent years. In this paper, we propose a highly applicable refractory perfect absorber with an elliptical titanium nanodisk array based on a silica–titanium–silica–titanium four-layer structure. Through theoretical design and numerical demonstration, the interaction of surface plasmon resonance with the Fabry–Perot cavity resonance results in high absorption characteristics. Our investigations illustrate that it can achieve ultra-broadband absorption above 90% from a visible 550-nm wavelength to a near-infrared 2200-nm wavelength continuously. In particular, a continuous 712-nm broadband perfect absorption of up to 99% is achieved from wavelengths from 1013 to 1725 nm. The air mass 1.5 solar simulation from a finite-difference time domain demonstrates that this absorber can provide an average absorption rate of 93.26% from wavelengths of 295 to 2500 nm, which can absorb solar radiation efficiently on the earth. Because of the high melting point of Ti material and the symmetrical structure of this device, this perfect absorber has excellent thermal stability, polarization independence, and large incident-angle insensitivity. Hence, it can be used for solar cells, thermal emitters, and infrared detection with further investigation.

A common-path dual-wavelength phase demodulation technique for extrinsic Fabry–Perot interferometric (EFPI) sensors is proposed on the basis of a broadly tunable modulated grating Y-branch (MG-Y) laser. It can address the three main concerns of existing dual-wavelength phase interrogation methods: the imbalances and disturbances caused by two optical paths utilizing two lasers or two photodetectors, the restrictions between two operating wavelengths and the cavity length of EFPI, and the difficulty in eliminating the direct current (DC) component of the interferometric fringe. Dual-wavelength phase interrogation is achieved in a common optical path through high-speed wavelength switching. Taking advantage of the MG-Y laser’s full spectrum scanning ability (1527 ∼ 1567 nm), initial cavity length and DC component can be directly measured by white light interferometry. Two quadrature wavelengths are then selected to perform high speed phase demodulation scheme. Three polyethylene terephthalate (PET) diaphragm based EFPI acoustic sensors with cavity lengths of 127.954 µm, 148.366 µm and 497.300 µm, are used to demonstrate the effectiveness.

In this paper, a tilted fiber Bragg grating (TFBG) plasmonic sensor based on thymine (T) - Hg - thymine (T) (T-Hg-T) base asymmetric pairing and Au nanoparticles (AuNPs), which can be used for highly sensitive and selective ultra-low-concentration Hg2+ detection, has been demonstrated. As is known, TFBG can provide an effective mean to easily excite the surface plasmon resonance (SPR) phenomenon while the fiber is coated with metal layer. By measuring the evolution of spectra, the SPR properties hence the surface perturbation could be detected accurately. To achieve highly sensitive and selective Hg2+ detection, the two specially designed single-strand probe DNAs (ssDNAs) with rich T base that can specifically forming stable T-Hg-T asymmetric pairing are served as a binding element for AuNPs labelled-target DNA conjugates. In the present of Hg2+, these two ssDNAs that modified respectively on the surface of the sensor and the AuNPs will create a double helix T-Hg-T structure between the two DNA oligonucleotides and result in the surface refractive index perturbation amplified by the AuNPs. To overcome the low reusability of the AuNPs based DNA biosensor, by using iodide ions that can form more stable compounds with mercury ions over the T-Hg2+-T structure, a regenerable DNA biosensor that can repeatedly detect mercury ions is developed. The experimental results demonstrate that this sensor shows an excellent ultra-low-concentration and selectivity detection capability for Hg2+ with the limit of detection (LOD) of ${3.073 \times 10^{-12} M \ (3.073 pM)}$ as well as a large dynamic range of 8 order of magnitude from ${1.0\times 10^{11}\rm \ M \ to \ {1.0\times 10^{3}} M}$ simultaneously. Thus, the experimental results in various actual sample from ultrapure/tap water to even clinical human serum, also reveal that it has potential application for Hg2+ detection in environmental samples and in clinic biological samples.

In this Letter, we propose a quadrature phase-stabilized three-wavelength demodulation technique for the interrogation of fiber-optic Fabry–Perot acoustic sensors. It is based on accurate and fast tuning of a monolithic modulated grating Y-branch laser. Three quadrature wavelengths are chosen to perform high-speed cavity length demodulation by wavelength switching, thereby avoiding imbalances and disturbances between the three optical paths in conventional three-wavelength quadrature phase-demodulation systems. A feedback-stabilization scheme for maintaining the quadrature phase condition is proposed for the first time, to the best of our knowledge, providing potential for long-term monitoring in harsh environments.

We proposed and demonstrated a novel tilted fiber Bragg grating (TFBG)-based surface plasmon resonance (SPR) label-free biosensor via a special boronic acid derivative to detect glycoprotein with high sensitivity and selectivity. TFBG, as an effective sensing element for optical sensing in near-infrared wavelengths, possess the unique capability of easily exciting the SPR effect on fiber surface which coated with a nano-scale metal layer. SPR properties can be accurately detected by measuring the variation of transmitted spectra at optical communication wavelengths. In our experiment, a 10° TFBG coated with a 50 nm gold film was manufactured to stimulate SPR on a sensor surface. To detect glycoprotein selectively, the sensor was immobilized using designed phenylboronic acid as the recognition molecule, which can covalently bond with 1,2- or 1,3-diols to form five- or six-membered cyclic complexes for attaching diol-containing biomolecules and proteins. The phenylboronic acid was synthetized with long alkyl groups offering more flexible space, which was able to improve the capability of binding glycoprotein. The proposed TFBG-SPR sensors exhibit good selectivity and repeatability with a protein concentration sensitivity up to 2.867 dB/ (mg/mL) and a limit of detection (LOD) of 15.56 nM.

A differential-pressure fiber-optic airflow (DPFA) sensor based on Fabry-Perot (FP) interferometry for wind tunnel testing is proposed and demonstrated. The DPFA sensor can be well coupled with a Pitot tube, similar to the operation of the differential diaphragm capsule in the airspeed indicator on the aircraft. For differential pressure sensing between total pressure and static pressure in the airflow, an FP cavity is formed between the sensing diaphragm and a fiber end-face, and a tubule is inserted into the FP cavity. According to the principle of differential pressure derived from Bernoulli’s equation, the airflow velocity can be determined by monitoring the change of the FP cavity length. The experimental results demonstrate that a DPFA sensor with 0∼11 kPa measurable range, 826.975 nm/kPa sensitivity, and 0.008% (0.89 Pa) resolution can be realized. Combined with a 100 Hz-sweep frequency self-developed white light interferometric (WLI) interrogator and a Pitot tube, the DPFA sensor can be used for measuring the airflow velocity of 2.0∼119.24 m/s with an accuracy of 0.61%. The system is applied to the analysis of the flat-plate boundary layer, a wind tunnel experimental model, where the results are consistent with those of the theoretical analysis and from the standard electronic pressure transducer. With the large measurable range, high sweep frequency, and high precision, the system has potential application value for wind tunnel experimental investigation and in-flight measurement of airspeed.