Centrifugal compressor performance is affected by many parameters, optimization of which can lead to superior designs. Recognizing the most important parameters affecting performance helps to reduce the optimization process cost. Of the compressor components, the impeller plays the most important role in compressor performance, hence the design parameters affecting this component were considered. A turbocharger centrifugal compressor with vaneless diffuser was studied and the parameters investigated included meridional geometry, rotor blade angle distribution and start location of the main blades and splitters. The diffuser shape was captured as part of the meridional geometry. Applying a novel approach to the problem, full factorial analysis was used to investigate the most effective parameters. The Response Surface Method was then implemented to construct the surrogate models and to recognize the best points over a design space created as based on the Box-Behnken methodology. The results highlighted the factors that affected impeller performance the most. Using the Design of Experiment technique, the model which optimized both efficiency and pressure ratio simultaneously delivered a design with 3% and 11% improvement in each respectively in comparison to the initial impeller at the design point. Importantly, this was not at the expense of sacrificing range, of critical concern in compressor design.

The performance of an automotive turbocharger centrifugal compressor has been studied by developing a comprehensive one-dimensional (1D) code as verified through experimental results and a three-dimensional (3D) model. For 1D analysis, the fluid stream in compressor is modeled using governing gas dynamics equations and the loss mechanisms have been investigated and added to the numerical model. The objective is to develop and offer a 1D model, which considers all loss mechanisms, slip, blockage and also predicts the surge margin and choke conditions. The model captures all features from inlet duct through to volute discharge. Performance characteristics are obtained using preliminary geometry and the blade characteristics. A 3D numerical model was also created and a viscous solver used for investigating the compressor characteristics. The numerical model results show good agreement with experimental data through compressor pressure ratio and efficiency. The effect of the main compressor dimensions on compressor performance has been investigated for wide operating range and the portions of each loss mechanism in the impeller. Higher pressure ratio is achievable by increasing impeller blade height at outlet, impeller blade angle on inlet, diffuser outlet diameter and by decreasing impeller shroud diameter at inlet and blade angle at outlet. These changes may cause unfavorable consequences such as a lower surge margin or shorter operating range, which should be compromised with favorable changes. At lower rotational speeds, impeller skin friction mainly impacts the performance and at higher rotational speeds, impeller diffusion, blade loading and recirculation losses are more important. The results allow the share of each loss mechanism to be quantified for different mass flow rates and rotational speed, shedding new light on which losses are most important for which conditions. For a turbocharger, which must operate over a wide range of conditions, these results bring new insight to engineers seeking to optimize the compressor design as part of an internal combustion engine system.

In this research, design methods of radial flow compressor volutes are reviewed; the main criteria in volute primary designs are recognized and the most effective ones are selected. The effective parameters, i.e., spiral cross-section area, circumferential area distribution, exit cone, and tongue area of the compressor volute are parametrically studied to identify the optimum values. A numerical model has been prepared and verified through experimental data which are obtained from the designed turbocharger test rig. Different volutes are modeled and numerically evaluated using the same impeller and vane-less diffuser. For each model, the volute total pressure ratio, static pressure recovery and total pressure loss coefficients and the radial force on the impeller are calculated for different mass flow rates at design point and off-design conditions. The volute which shows better performance and causes lower the net radial force on the impeller at desired mass flow rates is selected as an optimal one. The results show the volute design approach differences at the design point and off-design conditions. Improving the pressure ratio and reducing total pressure loss at design point may result in the worse conditions at off-design conditions as well as increasing radial force on the impeller.