Integrated geophysical methods have been used to investigate the competency of the subsoil. The geophysical surveys conducted involve very low-frequency electromagnetic (VLF-EM) and electrical resistivity (ER) methods (dipole-dipole). ABEM Wadi and Ohmega resistivity meter were used to acquire VLF-EM and ER data, respectively, along two traverses. Station interval of 5 m was used for the VLF-EM survey, while inter-electrode spacing for dipole–dipole was 10 m; the inter-dipole expansion factor (n) ranged from 1 to 5. KHFFILT software was used to generate VLF-EM profiles and pseudosection, while DIPRO software was used for ER. Results from the ER method revealed the pattern of resistivity variations within the study area. The low resistivity values (11–25 Ohm-m) observed at the southern part of the study area could be attributed to changes in clay contents and degree of weathering in the subsurface. The results from the VLF-EM investigation revealed the presence of near-surface linear geologic structures of varying lengths, depths and attitudes, which suggest probable conductive zones that are inimical to the foundation of the road subgrade.
17 July 2018 in IOP Conference Series: Earth and Environmental Science
The principles of equivalence and suppression in resistivity sounding technique are phenomena where different resistivity models may produce resistivity curves that are essentially the same. The understanding of these phenomena could be of great importance in using resistivity sounding technique for citing boreholes in places underlain by Basement Complex rocks. In such areas, it would be difficult to identify the fractured/weathered bedrock from the sounding interpretation. This is because the resistivity of the weathered layer is usually intermediate between those of the adjacent layers (i.e. residual overburden) on top and the fresh bedrock below. Therefore, it is important to analyse the problems of suppression and equivalence in resistivity sounding data for estimating thickness and resistivity of the subsurface layers. Several resistivity models were generated ranging from two-layer to five-layer models to investigate these phenomena. The apparent resistivity curves were plotted for these models. The results show that the problems of suppression and equivalence exist in resistivity sounding data. Hence, geophysicists should not make any a priori quantitative inferences using the shape of the resistivity sounding curve.