Thermal-induced degradation of modulation transfer function (MTF) and image sharpness in automotive camera modules under large real-world temperature variations is a key bottleneck for the safe deployment of level 3 and higher advanced driver assistance systems. To address this challenge, a collaborative passive compensation framework is proposed to maintain high-resolution imaging performance across extreme temperature conditions. Within this framework, an elastic spacer is embedded into the lens stack as an additional optical design degree of freedom. This carefully engineered element expands the thermal focus compensation capability of the lens assembly and suppresses inherent back focal plane (BFP) drift within a narrow range through coordinated opto-mechanical coupling optimal design. Then, a metal stiffener plate is introduced to tailor the thermo-mechanical deformation behavior of the detector-mounted printed circuit board. By optimizing the thickness of the stiffener plate, the residual thermally induced BFP drift of the overall opto-mechanical system is effectively counteracted, enabling global opto-mechanical–thermal equilibrium. Experimental results from the prototype camera module demonstrate that, over an ultra-wide temperature range from −40 °C to +95 °C, the maximum absolute BFP mismatch between the lens optical focus plane and the image sensor plane is constrained within 1, achieving ∼90% reduction compared with conventional optical-only athermalization approaches. At a spatial frequency of 119 lp/mm, the MTF at the center and the left/right 0.7-field positions consistently exceeds the design threshold of 0.5 with negligible degradation throughout the full temperature range. These results demonstrate that the proposed approach enables a fully passive, temperature-invariant automotive camera module, achieving an optimal balance among compactness, cost efficiency, and robustness under harsh automotive operating conditions.
Cameras have become indispensable sensors in intelligent vehicles, with their deployment steadily increasing across modern automobiles. It is critical for camera modules to have reliable and accurate environmental perception, but a major challenge is condensation inside the modules that severely compromises imaging quality. To address this issue, we performed comprehensive thermodynamics-based simulations to clarify condensation mechanisms and evaluate their impact on optical imaging performance. Based on these insights, we proposed an integrated optical–structural optimization strategy that reduces the internal cavity volume adjacent to the first lens, simultaneously increasing the first lens thickness and the curvature of its internal surface. This strategy both reduces water vapor volume and elevates the temperature of potential condensation zones. The optimized module exhibits markedly improved resistance to condensation compared with the baseline design in the experiment, raising the critical condensation threshold from a sudden temperature drop of 42 °C to over 60 °C. This approach effectively mitigates condensation under harsh environmental conditions without additional cost. Our simple yet effective design is broadly applicable to diverse automotive camera module architectures, thereby enhancing system reliability and improving the overall safety of autonomous driving.