This review explores the environmental impacts, technical challenges, and potential solutions for sustainable seawater electrolysis, offering insights into advancing this technology for green hydrogen production.
Electrochemical synthesis has been proposed as an efficient method for cost-effective and large-scale production of metal-organic frameworks (MOFs). This work investigates the combined electrochemical synthesis with flow synthesis post-treatment for the production of high surface area HKUST-1. The electrochemical synthesis process used in the experimental work did not require additional electrolytes or washing of the synthesis product. Batch electrosynthesis and electrosynthesis with flow synthesis were compared for the quality of the product using Brunauer–Emmett–Teller (BET) surface area, X-ray diffraction (XRD), and scanning electron microscopy (EIS). Batch electrosynthesis in 0.01 M benzene-1,3,5-tricarboxylic acid (H3BTC) solution produced HKUST-1 with BET surface area of 1550 m2/g which was increased further to 1716 m2/g with post-flow-synthesis treatment. The greatest change in surface area after flow processing was observed when using 0.78 M H3BTC, with corresponding surface areas of 481 m2/g and 1531 m2/g. According to SEM and BET results, the product purity improved during the post-flow-synthesis treatment. The proposed method enables continuous flow synthesis of high-quality MOFs with minimal purification steps.
4 January 2020 in Journal of the Electrochemical Society
Surface-mediated reactions require effective mixing for them to be intense and efficient. In electrochemistry where the reactants must contact electrode surfaces for a sufficient time to enable electron tunnelling to occur, exhaustive electrolysis in poorly stirred reactors can take many hours to complete. As a consequence, electrochemical processing in many industries is restricted to batch processing which is more costly and labour intensive than continuous processing and results in significant down time between batches. This is not ideal for bulk production or treatment. Here we describe CSIRO’s novel axial flow electrochemical cell which aims to address these mixing problems by using a bespoke static mixer electrode (SME), designed by computational fluid dynamics (CFD) and manufactured using additive manufacturing (AM) technology to retain the fidelity of the original design. This electrode was characterized by SEM-EDS and electrosorption measurements. The performance of the electrochemical flow cell was evaluated by probing the ferricyanide ([Fe(CN) 6 ] 3− ) reduction reaction on a platinum-coated SME under controlled mass transport conditions using cyclic voltammetry (CV), linear sweep voltammetry (LSV) and chronoamperometric measurements. This reaction was chosen because it has fast electron transfer kinetics, so the rate of reaction in dilute solutions is limited only by mass transport of the reactant to the electrode surface. Under the highest flow rate used (400 ml min −1 ) the cell enhanced the rate of reduction of ([Fe(CN) 6 ] 3− in a 10 −3 M solution by 45 times compared with the no flow result. The impact the cell has diminishes as the concentration increases where mass transport plays a diminishing role in controlling the reaction rate. The performance of the cell is compared with a rotating disk electrode and a tubular flow cell and mass transfer coefficients are also presented for different reactant concentrations and flow conditions.