» Evaluating the nutritional status of an orthopaedic patient prior to total joint arthroplasty can offer insight into potential postoperative outcomes. » Laboratory values, such as total lymphocyte count, serum albumin, and serum prealbumin, anthropometric measurements, and screening tools are all important resources in assessing nutritional status. » Using body mass index (BMI) in conjunction with laboratory values and other resources to adequately assess nutritional status can be effective in predicting outcomes after total joint arthroplasty.
» Nutritional risk in patients undergoing total joint arthroplasty has been well-studied with regard to diagnostic criteria; however, therapeutic management of abnormal body mass index (BMI) values and serum markers remains to be studied in patients undergoing joint replacement surgery. » Patients with a BMI value of >40 kg/m2 are at increased risk for postoperative complications; weight loss programs and bariatric surgery are therapeutic modalities that can be used in the prehabilitation and long-term rehabilitation of patients undergoing total joint arthroplasty. » Management of patients with abnormal nutritional status should be multidisciplinary and allow for the incorporation of dietitians and nutritionists in therapeutic planning. » Hypoalbuminemia correction can be completed intravenously or orally; however, arthroplasty studies remain lacking with regard to the preferred modalities of correction.
Introduction: Locked intramedullary nailing (IMN) is the standard treatment for femoral shaft fractures in adults with high rates of union and relatively low rates of complications. Leg length discrepancy (LLD) after IMN of femoral shaft fractures is common, and is reported in 20–43% of cases. A known surgical challenge when trying to obtain equal leg lengths is comminuted fracture, which results in a loss of bony landmarks that guide reduction. The purpose of this study was to assess the effect of inherent tibial asymmetry on LLD measurements after IMN. Methods: Postoperative CT scanograms were performed on 79 consecutive patients after locked IMN for comminuted femoral shaft fracture. Leg lengths were determined by measurements taken from the scout view of a CT scanogram. Calculations of discrepancy were made for both femurs, tibias, and total leg length. Assessment was also made on the frequency wherein the tibial discrepancy compounded the femoral discrepancy. In situations where a limb segment was exactly symmetric to the contralateral side, the total leg was not regarded as a having compounded asymmetry. Results: Notable discrepancies were found in tibial length that significantly departed from the null of symmetry (p < 0.0001). Forty-two patients (53.2%) were found to have a tibial asymmetry of 3 mm or more, and 20 patients (25.3%) were found to exhibit a difference of 6.3 mm or more. Median femoral discrepancy was 5.3 mm and median tibial discrepancy was 3.0 mm. Seven patients were found to be asymmetric in total leg length as a consequence of underlying tibial asymmetry. Conversely, 11 patients benefited from their tibial asymmetry, which compensated for femoral asymmetry after IMN. Conclusion: Tibial symmetry cannot be assumed. If not accounted for, inherent tibial asymmetry may influence LLD after IMN of femur fractures.
* Only 1 study has evaluated the effect of polymorphisms on postoperative pain following total knee arthroplasty and total hip arthroplasty. * Opioids do not produce optimal analgesia for all patients; nevertheless, the personalization of opioid selection and dosing is not commonly practiced, most likely because of the paucity of evidence with regard to clinical outcomes and opioid pharmacogenomics in patients undergoing total joint arthroplasty. * Further clinical trials are still required to establish the reliability and efficacy of the pharmacogenomics panel tests.
22 January 2020 in International Journal of Pediatrics
Surgical site infection is a relatively common and devastating complication following pediatric orthopedic surgery. Many infections have been determined to be the result of settled airborne particles on surgical equipment and the sterile field. Fiberglass casts are commonly used orthopedic fixation devices before and after surgery; however, fiberglass casting material is expelled during the removal process and represents an uninvestigated area for the possibility of cast saw dust as a source of airborne bacterial contamination in an operating room setting. This study evaluates the prevalence and distribution of microbiota on 90 pediatric casts by collecting and culturing fiberglass cast material from 90 pediatric casts. Bacterial identification was performed using a Bruker Biotyper Matrix-Assisted Laser Desorption/Ionization Time-of-Flight Mass Spectrometry device. 81 out of 90 casts (90%) showed evidence of microbial contamination. Isolated species were very diverse and ranged from normal skin flora to opportunistic pathogens. The 5 most commonly isolated organisms were Acinetobacter pittii, Enterobacter cloacae, Micrococcus luteus, Staphylococcus epidermidis, and Staphylococcus hominis. Further investigation is required to determine if casting material is truly a cause of surgical site infection.