The use of non-ergodic approaches for calibrating ground-motion prediction models is increasingly well established in the seismological and engineering literature. Specifically, the residuals (logarithmic difference between observed and predicted intensity measures) obtained from the calibration of a parametric model are decomposed to identify repeatable effects related to event, station and any other recurring properties (e.g. source and propagation effects). For the empirical estimation of the site effect, we refer to the repeatable station term, usually called δS2S (site-to-site), which measures the systematic deviation of seismic motion at a station from a reference ground motion prediction for that site category. In order to obtain an amplification function from δS2S estimates, the prediction of a rock site, real or modeled on the basis of a Ground Motion Model, can be taken as a reference prediction. In this work, we discuss our experience in estimating empirical amplification functions from δS2S of permanent and temporary recording stations in Italy, highlighting limitations and advantages of this approach. The results are also discussed in the perspective of the estimation of the amplification factors, useful for the seismic microzonation studies. The values of δS2S (with associated aleatory uncertainty) are published on the ITACA (ITalian ACcelerometric Archive) web page for 916 recording stations for PGA, PGV, 36 ordinates of the acceleration response spectrum (damping 5%) in the range T = 0.01–10 s.
Multiparametric surveys and installations performed recently in the Norcia basin (Italy) are presented to provide a multidisciplinary case study aimed at illustrating a new concept scheme of data processing and site characterization. Moving from source detection, seismic wavefield propagation and local response, the study also takes into account the dynamics of crustal fluids and gas ascent in relation to active tectonic processes. From December 2023 to July 2025, one multiparametric station was installed southeast of the inhabited centre of Norcia, enabling to collect seismological, geochemical and hydrogeochemical data. Moreover, during the summer of 2024, detailed geophysical surveys were performed to characterize the stratigraphic setting of the shallow deposits: active Multichannel Analysis of Surface Waves (MASW) were performed combined with passive seismic ambient noise measurements using dense nodal array configurations at 5 selected sites analysed by extended spatial autocorrelation methods. In the same period, integrated geological and geochemical surveys consisting of soil gas measurements (concentrations and fluxes) performed along three transects perpendicular to the main fault alignments, were also performed. Gas samples were collected and analysed for chemical composition and carbon isotopes of CO2 to detect any eventual active tectonic influence on the migration of soil gases towards the surface and to observe their spatial distribution during an inter-seismic period, also useful to evidence possible active buried local structures. Finally, the new seismostratigraphic model of the northern part of the basin is presented and used at two target sites as input for 1D numerical modelling assuming linear soil conditions. The theoretical 1D transfer functions are compared to the HVSR curves evaluated from both ambient noise signals and earthquake waveforms recorded in the Norcia basin in the last 10 years.