A method and system for measuring multiple temperature points using two wire configuration Resistance Temperature Detectors (RTD) for temperature range −100°C to +100°C is mainly composed of the Micro Controller Unit (MCU), analog–digital converter (ADC), reference Voltage source, Multiplexers (MUX) and resistance network including the RTD temperature sensors. The RTDs are sequentially scanned using a reference/constant voltage source, and resistance values of the RTDs are calculated based on the voltage measured across the RTDs and the current sensing resistor. Improving the precision of temperature measurement is based on a line fitting algorithm—Newton’s divided differences interpolation polynomial based on three reference resistor values representing two extreme end points and the center point of the temperature range for which the system is made. The test results show that the device temperature measurement precision can reach ±0.02°C, has the advantage of using a single quartic function for the entire temperature range −100°C to +100°C with dynamic calibration to address errors related to in-circuit resistance, tolerance, temperature coefficient, linearity and offset errors in the circuit, and also supports detection of degradation of linearity and offset in the circuit because of the aging factor.
1 November 2013 in International Journal of Bifurcation and Chaos
The MyoStep project, developed at the University of Houston (UH) and funded by the IEEE Electron Devices Society (EDS) Award, exemplifies the transformative potential of technology in addressing global challenges. This humanitarian initiative focuses on creating a lightweight, soft exoskeleton to assist children with cerebral palsy (CP), improving mobility and enhancing their quality of life. Beyond its humanitarian impact, MyoStep serves as an unparalleled educational platform, offering undergraduate students, particularly those from underrepresented groups in science, technology, engineering, and mathematics (STEM), hands-on experience in cutting-edge fields such as smart materials; wearable technology; and biomedical, electrical, and computer engineering. By merging technical excellence with a mission-driven purpose, MyoStep not only inspires the next generation of engineers but also embodies the IEEE EDS vision of advancing technology for the benefit of humanity.
Brain-machine interfaces (BMIs) translate brain signals into motor commands for assistive devices. Despite significant advances, the long-term effects of BMI training on neural adaptation, classifier stability, and individual variability remain poorly understood. We present a multimodal, longitudinal dataset collected from seven healthy participants over nine sessions spanning 15 to 81 days. The dataset includes high-density electroencephalography (EEG), electrooculography (EOG), inertial measurement unit (IMU) data, and exoskeleton state information during BMI control. During the open-loop training phase, participants performed kinesthetic motor imagery (KI) while a remotely controlled exoskeleton executed walking and stopping commands. After the open loop training phase, the system transitioned to closed loop BMI control. For closed-loop control, lower delta band EEG signals were classified using Local Fisher Discriminant Analysis and a Gaussian Mixture Model. The classifier was continuously updated using open-loop data from Sessions#1-5, after which its parameters were fixed. The dataset also includes post-experiment MRI scans from five participants performing KI while viewing themselves walking in the exoskeleton. This report outlines the experimental setup, data collection, and preliminary validation, providing a resource for future BMI research.