A novel mode-localized acceleration sensor employing an electrostatically coupled resonator and integrating a lever with proof mass is micromachined using standard silicon on insulator (SOI) technology. In order to determine the linear dynamic range of the sensor, a reduced order model is developed while assuming that the resonators vibrate below the critical amplitude. Then, open-loop and closed-loop testing platforms are established to measure the performance of the linearly operating accelerometer in a vacuum environment (less than 5 Pa). Moreover, the corresponding amplifier circuit based on the capacitive detection principle is designed in order to extract and amplify the current signal from the resonators. The obtained results show that the accelerometer sensitivity can be increased by three orders of magnitude when using the relative shift of amplitude ratio as the output metric instead of the relative shift of frequency, and the experimental measurements are consistent with the theoretical predictions. Remarkably, the Allan standard deviation of the mode-localized acceleration sensor obtained from the closed-loop testing circuit is around 5.03 μg.
24 June 2024 in Journal of Microelectromechanical Systems
The snap through phenomenon of curved beam structures offers the possibility for designing high-performance filters, however, superharmonic resonances outside the filter’s passband are difficult to be attenuated. Therefore, a two-stage bandpass filter incorporating two electromagnetically coupled curved microbeams is designed, which possesses excellent specifications of sharp switching in the stopband and flat bandwidth compared to single curved-beam based filter. The reduced-order model considering the nonlinear electromagnetic forces and geometric nonlinearities is established, and discretized using the Galerkin method. Then, the resulting static and dynamic reduced order models are numerically solved. Extensive numerical simulation results show that the improved filter has a rectangular coefficient close to 1.0, a passband ripple of 0.2 dB, and a bandwidth ratio of 14.8%, which drastically reduces the stopband interference to 10% of the passband signal. Finally, the effects of DC voltage, AC voltage and coupling strength on the center frequency and bandwidth are parametrically investigated, where the center frequency can be tuned between 23.81 kHz and 25.16 kHz and the bandwidth covers the frequency range from 22.46 kHz to 26.05 kHz.2024-0054
Bifurcation topology transfer phenomena in the presence of mode localization are investigated using double-ended fixed electrostatically coupled tuning fork resonators. An analytical model is proposed for the coupled tuning fork resonators, and the effects of feedthrough capacitance on the structure are also analyzed and eliminated by means of data post-processing. Then, an open-loop experimental platform is established, when the system is in balance state, the quality factor is obtained under test as Q = 9858, and comparison of the experiment with numerical simulation results is in good agreement. Finally, with the voltage increases, the two resonators gradually exhibit nonlinear characteristics. It is worth noting that when one of the coupled resonators exhibits nonlinear vibration behavior, even though the vibration amplitude of the other resonator is lower than the critical amplitude, it still exhibits nonlinear behavior, and the results confirm the existence of the bifurcation topology transfer phenomenon in coupled resonators’ mode localization phenomenon.
29 September 2026 in European Journal of Mechanics - A/Solids