Electro-optical modulators are effectively used for ultrafast pulse lasers operation control. The scheme of picosecond pulse-periodic high-peak-power Nd:YAG lasers is composed of an active-passive mode-locked and negative feedback-controlled master oscillator and regenerative amplifier based on common end-diode-pumped Nd:YAG crystal. A double-crystal thermally compensated Pockels cell based on KTP crystals of the Y-cut direction is employed as a key control element. The cell was assembled using a pair of equal-length crystals grown according to high-resistivity technology. The scheme provides output pulses with energy up to 1.6 mJ, a duration of 25 ps at repetition rates tunable from 0 to 200 Hz. The laser operation stages are analyzed in detail. The scheme looks attractive and promising for developing advanced ultrafast laser systems with higher repetition rates, peak and, accordingly, average power levels. The Pockels cell based on KTP crystals expands the line of available fast electro-optical control elements, along with the previously used RTP ones. The factors limiting laser pulse energy and repetition rate are discussed. Parasitic nonlinear conversion in the crystals of the Pockels cell along the axis may play an essential role. The results of comparative measurements of the second and third harmonics made with the Pockels cells based on KTP and RTP crystals of both X-cut and Y-cut directions are presented. The minimum second and third harmonics efficiency levels observed in the Y-cut Pockels cells of the KTP crystal seem to be their important advantage.
25 August 2021 in IEEE Journal of Quantum Electronics
The concept of the self-starting harmonic mode-locking (SSHML) by electro-optical feedback in a solid-state laser is studied. Such an operational mode with m equidistant pulses in a laser cavity is controlled by a delayed single negative electro-optical feedback loop which comprises an intracavity electro-optical modulator and a fast high-voltage photodiode mounted directly on it. Analytical expressions for the feedback delay time and the short pulse duration are derived depending on laser parameters. The build-up time of the SSHML process and the limiting gain values are assessed by a high-resolution numerical simulation. For the purposes of accelerator physics, the pulse duration estimations for a set of the widely used Nd and Yb active media are provided. Robustness, high limiting gain and low sensitivity to gain level make SSHML laser an attractive platform for future multi-bunch photoinjector design.
In this work, aiming at the master oscillator of the photoelectron gun with a variable repetition rate of electron bunches, a picosecond solid-state laser subject to delayed optoelectronic feedback and RF loss modulation is studied. Loss modulation is performed using an electro-optical modulator with zero bias at the second accelerator frequency subharmonic. Optoelectronic negative feedback uses an intracavity electro-optical modulator and a fast high-voltage photodiode mounted as close as possible to the modulator crystal. An analytical formula is obtained for the pulse duration, and estimates are given for Nd and Yb based media and L, S, C and X-band used in modern linear accelerators. Numerical simulation proves that the control is suitable for pulse-repetitive operation. The proposed approach solves the problem of laser pulse shortening and locking the master oscillator, and therefore, electron bunches in photoelectron guns, to the high-stable RF generator controlling accelerator functioning.
Cascaded stimulated polariton scattering (SPS) under powerful picosecond pumping of 532 nm wavelength was investigated in a single pass of a KTP (KTiOPO4) crystal. Under ordinary polarization of the pump wave (relatively XOZ-plane) parametric scattering in the KTP crystal was observed. By rotation of the pump wave polarization (from ordinary to extraordinary), this scattering gradually transforms into polariton scattering. Polariton signal components (spots) with gaps between them were registered at external angles of ~2° between the neighboring spots. Five polariton signal components were detected above the pump beam, with a frequency difference between neighboring cascaded components of ~188 cm−1 (5.64 THz). The wavelength of each next component increased regularly with the angle between this component and the pump wave, so this regular sequence of polariton signal components can be regarded as a cascaded SPS.