Zeolites are potentially a robust desalination alternative, as they are chemically stable and possess the essential properties needed to reject ions. Zeolite membranes could desalinate “challenging” waters, such as saline secondary effluent, without any substantial pre-treatment, due to the robust mechanical properties of ceramic membranes. A novel MFI-type zeolite membrane was developed on a tubular α-Al2O3 substrate by a combined rubbing and secondary hydrothermal growth method. The prepared membrane was characterised by scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS) and single gas (He or N2) permeation and underwent desalination tests with NaCl solutions under different pressures (0.7 MPa and 7 MPa). The results showed that higher pressure resulted in higher Na+ rejection and permeate flux. The zeolite membrane achieved a good rejection of Na+ (~82%) for a NaCl feed solution with a TDS (total dissolved solids) of 3000 mg·L−1 at an applied pressure of 7 MPa and 21 °C. To explore the opportunity for high salinity and high temperature desalination, this membrane was also tested with high concentration NaCl solutions (up to TDS 90,000 mg·L−1) and at 90 °C. This is the first known work at such high salinities of NaCl. It was found that increasing the salinity of the feed solution decreased both Na+ rejection and flux. An increase in testing temperature resulted in an increase in permeate flux, but a decrease in ion rejection.
1 October 2005 in Separation Science and Technology
A pilot scale, slurry type photocatalytic reactor, followed by submerged hollow fiber microfiltration (MF) membrane hybrid system was evaluated for simultaneous and complete destruction of toxic organic chemical bisphenol A (BPA) and separation of photocatalyst TiO2; in order to obtain a reusable quality water. With simple modification to the treatment operation, the effect of photocatalytic reaction at modest variations in temperature was examined. Adsorption pretreatment was carried out prior to photocatalysis (UV/TiO2). BPA adsorption ability on TiO2 was very less (about 15%) at 25°C. However, adsorption pretreatment followed by photocatalytic oxidation (UV/TiO2) at an elevated nearly constant temperature (about 70°C) helped in increasing the BPA degradation efficiency. The effect of ozone introduction into the treatment stream was also analyzed. Applying ozone along with UV/TiO2, brought about a synergistic effect on BPA degradation. Within 3 h, entire 10 ppm of BPA and the by‐product organic compounds were completely removed. TiO2 particle separation performance using hollow fiber membrane was enhanced by adopting a two‐stage coagulation/sedimentation pretreatment. With initial turbidity of 4000 NTU, the turbidity of the final permeate water was well below 0.1 NTU. Almost complete removal of particles was achieved. Some of the main advantages of this hybrid treatment system include, large‐scale treatment, complete and efficient BPA and its organic intermediates degradation, TiO2 easily separated after treatment and capable for reuse as it is free from chemical coagulant contaminants, reusable quality water is obtained, and the system has the potential for continuous operation with simple process modifications.