Silver nanowire (Ag NW) is used as an attractive alternative material to fabricate flexible transparent conductive electrodes (TCE) instead of indium tin oxide, which has brittle characteristics and unstable processing expenses. For practical applications of Ag NW TCE, a proper patterning process is essential because the Ag NW layer is usually formed from the solution process. Laser ablation is one of the promising patterning processes for fabricating Ag NW-based optoelectronic devices. Among the laser processes, the nanosecond near-infrared pulsed laser ablation (NIR PLA) is considered advantageous because it is cheaper than ultrashort or ultraviolet pulsed lasers and causes little damage to the flexible substrate. However, since the Ag NW absorbance in this wavelength is very low, laser processing of Ag NW can deteriorate processing quality due to the remaining debris that resulted from incomplete evaporation of Ag NW. In this study, we report NIR PLA of Ag NW in aqueous media that improved the processing results of Ag NW laser patterning. We found that effective debris removal with a low fluence was a result of advantages such as the reduced heat-affected zone and dispersion of silver nanoparticle debris in the liquid media. Under different processing parameters, the performance of patterned Ag NW improved in liquid media compared to the ambient condition. Significant improvements in the processing quality were also observed in the laser patterning of Ag NW on the flexible substrate without any degradation. Consequently, the patterned flexible Ag NW TCE was successfully fabricated via the proposed process.
5 November 2025 in Journal of Micromechanics and Microengineering
Even though silver nanowire (AgNW) films are one of the promising alternatives to indium tin oxide (ITO), the limitation of AgNW is still lower electrical conductivity compared to ITO. In this paper, we report the improvement in electrical conductivity of AgNW transparent electrodes through thermal and optical treatment of an organometallic compound. Morphological analysis and finite-element time-domain confirmed that the enhanced intensity of the electric field in the nanowire structures enabled selective metallic junction reinforcement even with a low-intensity ultraviolet lamp. The junction-enhanced AgNW substrate showed improved mechanical properties compared to pristine AgNWs. An organic light-emitting diode device also showed a ∼ 30% improved luminance efficiency with the enhanced electrical conductivity. Due to the advantages of simple and low-cost junction enhancement without degradation in transmittance, the proposed method is expected to have practical applications in AgNW devices.
11 August 2025 in International Journal of Precision Engineering and Manufacturing
Conventional laser irradiation of polyimide (PI) films for flexible electrode fabrication is limited by uncontrolled ablation, compromising structural precision and functional integration. Here, a spatially confined, low‐energy laser‐induced direct‐write strategy is reported that enables precise control over carbonization and nanomaterial integration in flexible carbon‐based electrodes. In the proposed sandwich configuration, a PI film is confined between two glass substrates during nanosecond (ns) laser irradiation, governing localized heat absorption and diffusion to achieve controlled graphitization with minimal structural damage. The confinement architecture further facilitates the laser‐induced reduction of a copper (Cu) metal–organic framework (Cu‐MOF) precursor, thereby enabling selective in situ incorporation of electroactive Cu nanoparticles directly into the carbon matrix. Optimization of the confinement geometry and laser parameters yields electrodes comprising highly graphitized, sheet‐like carbon structures with uniformly dispersed spherical Cu nanoparticles, improving both electrical conductivity and surface catalytic activity. The fabricated flexible electrodes are used as nonenzymatic glucose sensors, achieving a wide linear detection range (from 0.25 µ m to 10 m m ), a sensitivity of 2586.1 µA m m −1 cm −2 (0–1 m m ), and a detection limit of 2.72 µ m . Stable electrochemical performance is retained for the fabricated electrodes under repeated mechanical deformation, validating the robustness of this laser‐processing strategy for sensing applications.