Hierarchical Ru- and RuO 2 -foams show excellent cyclability and good oxygen efficiency when used as catalyst cathode material for lithium–oxygen batteries.
18 December 2013 in Journal of Materials Chemistry A
We report a simple two-step fabrication process of 3D porous Si/copper films by an electrodeposition method using a hydrogen gas bubble template. A 3D porous Si/copper film provides a large surface area, a highly conductive pathway, a short ion diffusion length, and buffer spaces to accommodate the stress during the cycling processes.
Lithium-Ion Batteries (LIB) are growing in popularity for many applications. Much research has been focusing on battery performance improvement. However, few studies have overcome the disadvantages of the conventional LIB manufacturing processes. Laser cutting of electrodes has been applied. However, the effect of electrodes’ chemical, physical, and geometrical characteristics on the laser cutting has not been considered. This study proposes the effect of compression of cathode on laser cutting for lithium-ion batteries. The kerf width and top width of the specimens with laser irradiation are measured and the material removal energy is obtained. Observations of SEM photographs and absorptivity measurements are conducted. Increasing volume energies causes logarithmic increases in the kerf and top width. It is observed that the compressed cathode forms a wider kerf width than the uncompressed cathode under the same laser parameters. The top width of the uncompressed cathode is wider than the uncompressed cathode. The compression has a favorable effect on uniform cutting and selective removal of an active electrode.
12 August 2015 in Journal of Materials Chemistry A
N-doped carbon materials were prepared by in situ electrochemical pre-treatment of a carbon electrode in a deaerated non-aqueous electrolyte containing lithium nitrate. Li–O2 batteries, applying the novel N-doped carbon electrode, show a significantly reduced overpotential and enhanced O2-evolution efficiency.
Separators play an essential role in lithium (Li)-based secondary batteries by preventing direct contact between the two electrodes and providing conduction pathways for Li-ions in the battery cells. However, conventional polyolefin separators exhibit insufficient electrolyte wettability and thermal stability, and in particular, they are vulnerable to Li dendritic growth, which is a significant weakness in Li-metal batteries (LMBs). To improve the safety and electrochemical performance of LMBs, Al2O3 nanoparticles and nanocellulose (NC)-coated non-woven poly(vinylidene fluoride)/polyacrylonitrile separators were fabricated using a simple, water-based blade coating method. The Al2O3/NC-coated separator possessed a reasonably porous structure and a significant number of hydroxyl groups (-OH), which enhanced electrolyte uptake (394.8%) and ionic conductivity (1.493 mS/cm). The coated separator also exhibited reduced thermal shrinkage and alleviated uncontrollable Li dendritic growth compared with a bare separator. Consequently, Li-metal battery cells with a LiNi0.8Co0.1Mn0.1O2 cathode and an Al2O3/NC-coated separator using either liquid or solid polymer electrolytes exhibited improved rate capability, cycle stability, and safety compared with a cell with a bare separator. The present study demonstrates that combining appropriate materials in coatings on separator surfaces can enhance the safety and electrochemical performance of LMBs.