Surface albedo is a critical parameter in surface energy balance, and albedo change is an important driver of changes in local climate. In this study, we developed a workflow for landscape albedo estimation using images acquired with a consumer-grade camera on board unmanned aerial vehicles (UAVs). Flight experiments were conducted at two sites in Connecticut, USA and the UAV-derived albedo was compared with the albedo obtained from a Landsat image acquired at about the same time as the UAV experiments. We find that the UAV estimate of the visibleband albedo of an urban playground (0.037 ± 0.063, mean ± standard deviation of pixel values) under clear sky conditions agrees reasonably well with the estimates based on the Landsat image (0.047 ± 0.012). However, because the cameras could only measure reflectance in three visible bands (blue, green, and red), the agreement is poor for shortwave albedo. We suggest that the deployment of a camera that is capable of detecting reflectance at a near-infrared waveband should improve the accuracy of the shortwave albedo estimation.
Fine particulate matters (PM2.5) and relative humidity (RH) in the ambient atmosphere are the leading anthropogenic and natural factors changing atmospheric horizontal visibility. Based on the analysis of environmental and meteorological data observed over 2013–2019 in Nanjing, an urban area in East China, this study investigated the influences of PM2.5 and RH on atmospheric visibility changes over recent years. The visibility had significantly negative correlations with the PM2.5 concentrations and RH changes. The nonlinear relationships existed between PM2.5 concentrations and visibility, as well as between RH and visibility, with the inflection points in the atmospheric visibility changes. The PM2.5 inflection concentrations were 81.0 μg m−3, 76.0 μg m−3, 49.0 μg m−3, and 33.0 μg m−3, respectively, for the RH ranges of RH < 60%, 60% ≤ RH < 80%, 80% ≤ RH < 90%, and RH ≥ 90%, indicating that the improvement of visibility with reducing PM2.5 concentrations could be more difficult under the humid meteorological condition. The visibility changes were most sensitive to PM2.5 concentrations in the RH range of 60–80% in this urban area of East China. The relative contributions of natural factor RH and anthropogenic factor PM2.5 to variations of wintertime atmospheric visibility were quantified with 54.3% and 45.7%, respectively, revealing an important role of natural factor RH in the change of atmospheric visibility in the urban area of East Asian monsoon region.
As the largest independent east–west-trending mountain in the world, Mt. Tianshan exerts crucial impacts on climate and pollutant distributions in central Asia. Here, the vertical structures of meteorological elements and black carbon (BC) were first derived at Mt. Tianshan using an unmanned aerial vehicle system (UAVS). Vertical changes in meteorological elements can directly affect the structure of the planet boundary layer (PBL). As such, the influences of topography and meteorological elements’ vertical structure on aerosol distributions were explored from observations and model simulations. The mass concentrations of BC changed slightly with the increasing height below 2300 m above sea level (a.s.l.), which significantly increased with the height between 2300–3500 m a.s.l. and contrarily decreased with ascending altitude higher than 3500 m. Topography and mountain–valley winds were found to play important roles in the distributions of aerosols and BC. The prevailing valley winds in the daytime were conducive to pollutant transport from surrounding cities to Mt. Tianshan, where the aerosol number concentration and BC mass concentration increased rapidly, whereas the opposite transport pattern dominated during nighttime.
The impact of structural variations in the atmospheric boundary layer (ABL) during the regional transport of air pollutants on its local pollution changes deserves attention. Based on multi-source ABL detection and numerical simulation of air pollutants over the Twain-Hu Basin (THB) during 4–6 January 2019, the mechanism of the rapid growth of atmospheric pollutant concentrations in Xianning by the synergistic effect of regional transport and ABL evolution is explored, and the main conclusions are obtained as follows. The vertically stratified atmosphere is noticeable at nighttime, and the heavy humidity of near-surface fog within the stable boundary layer (SBL) promoted the generation and cumulative growth of secondary PM2.5 components during the pollution formation stage. The horizontal transport characteristics of atmospheric pollutant concentration peak were observed in the residual layer (RL) of 500–600 m. At the pollution maintenance stage, the convective boundary layer (CBL) developed during the daytime, and northerly wind transported high-concentration pollutants from the north to the THB. Under the combined action of horizontal transport and turbulent mixing, the high-concentration atmospheric pollutants in the mixing layer (ML) from the ground to the 500 m height were mixed uniformly and maintained accumulation growth. The next day, the strong vertical turbulent mixing caused the downward transport of high-concentration pollutants in the RL during nighttime due to the development of the CBL again, resulting in a doubling of near-surface pollutant concentration in a short time. With the development of ABL turbulence, local pollution dissipated rapidly without the continuous input of pollutants from external regions. This study emphasizes the importance of multi-scale processes impact on pollution variation, that is, regional transport of atmospheric pollutants at the CBL development stage for the rapid growth of PM2.5 concentration in the ML.
The influence of the underlying surface on the atmospheric environment over rivers and lakes is not fully understood. To improve our understanding, this study targeted the Twain-Hu Basin (THB) in central China, with a unique underlying surface comprising a dense “water network” over rivers and lakes. In this study, the Weather Research and Forecasting Model with Chemistry (WRF-Chem) was used to simulate the impact of this dense “water network” on a wintertime heavy PM2.5 pollution event in the THB. On this basis, the regulating effects of density and area of the lake groups, with centralized big lakes (CBLs) and discrete small lakes (DSLs), on PM2.5 concentrations over the underlying surface of the dense “water network” in the THB were clarified, and the relative contributions of thermal factors and water vapor factors in the atmospheric boundary layer to the variation of PM2.5 concentrations were evaluated. The results show that the underlying surface of dense “water networks” in the THB generally decreases the PM2.5 concentrations, but the influences of different lake-group types are not uniform in spatial distribution. The CBLs can reduce the PM2.5 concentrations over the lake and its surroundings by 4.90–17.68% during the day and night. The ability of DSLs in reducing PM2.5 pollution is relatively weak, with the reversed contribution between −5.63% and 1.56%. Thermal factors and water vapor–related factors are the key meteorological drivers affecting the variation of PM2.5 concentrations over the underlying surface of dense “water networks”. The warming and humidification effects of such underlying surfaces contribute positively and negatively to the “purification” of air pollution, respectively. The relative contributions of thermal factors and water vapor–related factors are 52.48% and 43.91% for CBLs and 65.96% and 27.31% for DSLs, respectively. The “purification” effect of the underlying surface with a dense “water network” in the THB on regional air pollution highlights the importance of environmental protection of inland rivers and lakes in regional environmental governance. In further studies on the atmospheric environment, long-term studies are necessary, including fine measurements in terms of meteorology and the environment and more comprehensive simulations under different scenarios.