A number of studies have been performed to assess the potential of using supercritical carbon dioxide (S-CO2) in closed-loop Brayton cycles for power generation. Different configurations have been examined among which recompression and partial cooling configurations have been found very promising, especially for concentrating solar power (CSP) applications. It has been demonstrated that the S-CO2 Brayton cycle using these configurations is capable of achieving more than 50% efficiency at operating conditions that could be achieved in central receiver tower type CSP systems. Although this efficiency is high, it might be further improved by considering an appropriate bottoming cycle utilizing waste heat from the top S-CO2 Brayton cycle. The organic Rankine cycle (ORC) is one alternative proposed for this purpose; however, its performance is substantially affected by the selection of the working fluid. In this paper, a simple S-CO2 Brayton cycle, a recompression S-CO2 Brayton cycle, and a partial cooling S-CO2 Brayton cycle are first simulated and compared with the available data in the literature. Then, an ORC is added to each configuration for utilizing the waste heat. Different working fluids are examined for the bottoming cycles and the operating conditions are optimized. The combined cycle efficiencies and turbine expansion ratios are compared to find the appropriate working fluids for each configuration. It is also shown that combined recompression-ORC cycle achieves higher efficiency compared with other configurations.
21 July 2010 in International Journal of Energy Research
A high-temperature, sensible heat thermal energy storage (TES) system is designed for use in a central receiver concentrating solar power plant. Air is used as the heat transfer fluid and solid bricks made out of a high storage density material are used for storage. Experiments were performed using a laboratory-scale TES prototype system, and the results are presented. The air inlet temperature was varied between 300 °C to 600 °C, and the flow rate was varied from 50 cubic feet per minute (CFM) to 90 CFM. It was found that the charging time decreases with increase in mass flow rate. A 1D packed-bed model was used to simulate the thermal performance of the system and was validated with the experimental results. Unsteady 1D energy conservation equations were formulated for combined convection and conduction heat transfer and solved numerically for charging/discharging cycles. Appropriate heat transfer and pressure drop correlations from prior literature were identified. A parametric study was done by varying the bed dimensions, fluid flow rate, particle diameter, and porosity to evaluate the charging/discharging characteristics, overall thermal efficiency, and capacity ratio of the system.
1 June 2015 in Journal of Solar Energy Engineering
Supercritical carbon dioxide (s-CO2) can be used both as a heat transfer and working fluid in solar power tower plants. The main concern in the design of a direct s-CO2 receiver is the high operating pressures, i.e., close to 20 MPa. At such high pressures, conventional receivers do not exhibit the necessary mechanical strength or thermal performance. In this paper, a receiver based on compact heat exchanger technology is developed. The receiver consists of a group of plates with square-shaped channels which are diffusion bonded together to tolerate the high operating pressure. A computational model is developed and validated against data in the literature. Inconel 625 is used as the base material because of its superior resistance against corrosion in the presence of s-CO2. The receiver heats s-CO2 with mass flow rate of 1 kg/s from 530 °C to 700 °C under a solar flux density of 500 kW/m2. The influence of different parameters on the performance of the receiver is evaluated by a parametric analysis. Subsequently, a multi-objective optimization is performed to determine the optimal geometry of the heat exchanger considering the tradeoff between objective functions, such as unit thermal resistance and pressure drop. The design variables are hydraulic diameter, number of layers, and distance between the channels. The mechanical strength of the system is the constraint to the problem, which is evaluated using an ASME code for the pressure vessels. Finally, the temperature profiles inside the channels and the surface of the receiver are presented. It is shown that the fluid reaches the desired temperature while the maximum temperature of the surface remains well below the material limit.
22 May 2012 in Journal of Energy Resources Technology