Noodles are a product that has a large amount of consumption in Thailand. Therefore, it is important to extend the shelf life and increase the value of the noodles by drying. However, drying noodles has a relatively high energy consumption. For this reason, it is necessary to develop an energy-efficient drying process. Therefore, this research aims to study the drying of noodles using hot air combined with infrared stimulation. The drying performance was compared between the case with and without infrared stimulation. The experimental conditions were as follows: drying temperatures were 45, 50, and 55°C and hot air velocity were 1.0, 1.5, and 2.0 m/s. Criteria used to evaluate drying performance include drying rate and specific energy consumption. The study found that increasing in drying temperature and hot air velocity resulted in an increase in the drying rate and power of the dryer. Meanwhile, the specific energy consumption has decreased. It was also found that the drying efficiency of noodles using hot air combined with infrared stimulation was higher than the drying efficiency without infrared stimulation.
30 June 2025 in Journal of Advanced Research in Fluid Mechanics and Thermal Sciences
Hot air drying constitutes a critical preservation technique for Tilapia fillets, primarily aimed at reducing moisture content to inhibit microbial proliferation and extend shelf life. However, optimizing this process presents significant challenges due to the inherent sensitivity of Tilapia fillets to thermal and aerodynamic conditions, which profoundly influence both drying kinetics and product integrity. This study investigates the synergistic effects of varying drying temperatures (50°C, 60°C, 70°C) and air velocities (1.0 m/s, 1.5 m/s, 2.0 m/s) on drying kinetics and energy efficiency. Key performance indicators, including moisture content (MC), moisture ratio (MR), drying rate (DR), and specific energy consumption (SEC), were systematically evaluated. The results demonstrate that elevating the drying temperature to 70°C and increasing air velocity to 2.0 m/s significantly enhanced process efficiency, reducing drying time by 33%. Under these optimized conditions, the moisture content decreased from an initial 330% to below 50% within 200 minutes, while concurrently lowering the specific energy consumption (SEC) by 60% to 0.4 MJ/kg.
14 December 2025 in ASEAN Journal of Scientific and Technological Reports
This study presents a detailed experimental investigation into the energy and exergy efficiencies of a double-pass solar air heater (SAH) augmented with porous materials. The primary objective was to assess the impact of integrating steel-based hollow square porous elements, featuring porosities of 0.98 and 0.99, on the thermodynamic performance of the SAH under tropical environmental conditions. A prototype SAH with dimensions of 0.75 m × 1.85 m × 0.25 m was developed and evaluated based on empirical data encompassing solar irradiance, air inlet and outlet temperatures, and mass flow rate. The results demonstrate a significant improvement in both energy and exergy efficiencies with the incorporation of porous materials. Notably, the configuration with 0.98 porosity yielded superior results, with energy efficiencies ranging from 6.19% to 9.01% and a peak exergy efficiency of 0.26%. In comparison, the reference system without porous material exhibited lower average energy and exergy efficiencies of 4.98% and 0.11%, respectively. Furthermore, the porous media contributed to enhanced thermal inertia, leading to improved heat retention and a more stable outlet temperature profile under fluctuating solar irradiance. These findings underscore the thermodynamic advantages of utilizing high-porosity materials within a double-pass SAH, emphasizing their potential for efficient thermal energy conversion in agricultural and industrial drying applications, particularly in regions with high solar potential.