This paper presents an interleaved-boost converter, magnetically coupled to a voltage-doubler circuit, which provides a voltage gain far higher than that of the conventional boost topology. Besides, this converter has low-voltage stress across the switches, natural-voltage balancing between output capacitors, low-input current ripple, and magnetic components operating with the double of switching frequency. These features make this converter suitable to applications where a large voltage step-up is demanded, such as grid-connected systems based on battery storage, renewable energies, and uninterruptible power system applications. Operation principle, main equations, theoretical waveforms, control strategy, dynamic modeling, and digital implementation are provided. Experimental results are also presented validating the proposed topology.
13 October 2009 in IEEE Transactions on Power Electronics
This paper proposes the use of a three-phase high-frequency semicontrolled rectifier for wind energy conversion systems based on permanent magnet generators. The main advantages of the topology are: simplicity, since all active switches are connected to a common point, robustness, as short-circuit through a leg is not possible, and high efficiency due to reduced number of elements. As a disadvantage, higher but acceptable total harmonic distortion of the generator currents results. The complete operation of the converter and theoretical analysis are presented. Additionally, a single-phase pulsewidth modulation inverter is also employed in the grid connection. Experimental results on 5-kW prototype are presented and discussed.
20 February 2013 in IEEE Transactions on Power Electronics
This paper presents a novel high-voltage gain boost converter topology based on the three-state commutation cell for battery charging using PV panels and a reduced number of conversion stages. The presented converter operates in zero-voltage switching (ZVS) mode for all switches. By using the new concept of single-stage approaches, the converter can generate a dc bus with a battery bank or a photovoltaic panel array, allowing the simultaneous charge of the batteries according to the radiation level. The operation principle, design specifications, and experimental results from a 500-W prototype are presented in order to validate the proposed structure.
This study presents the qualitative and quantitative analyses, design procedure and experimental results on a soft switching cell applied to a high‐voltage gain interleaved boost converter. An active snubber cell is proposed as a possible solution for the increase of efficiency in a hard switching topology, where switching losses are drastically minimised. The main advantages of the introduced circuit are the common source terminal to all switches; zero‐voltage switching of the main switches; zero current switching of the auxiliary switches; low‐voltage stress across the switches; balanced voltage across the output capacitors; the presence of a magnetic coupling cell, which allows the gain to be significantly increased; and the magnetic components that are designed for twice the switching frequency. A prototype rated at 500 W is implemented and evaluated, where relevant issues are discussed to validate the theoretical assumptions.
30 August 2021 in IEEE Journal of Emerging and Selected Topics in Power Electronics
This article proposes a novel topology of a single-stage single-phase bidirectional ac–dc converter with high-frequency isolation feasible for onboard chargers. Its structure uses the interleaving concept associated with an autotransformer that is responsible for sharing the current stresses and increasing the current ripple frequency, as well as obtaining a five-level voltage waveform. A theoretical study of the structure, the operation principle, and a detailed loss analysis are performed. The mathematical analysis and control strategy are validated through simulations and a 1-kW small-scale experimental prototype. The topology is also redesigned to 6.6 kW and a comparison with a traditional two-stage solution usually employed in onboard chargers is presented, thus demonstrating that the proposed structure is competitive with other similar counterparts. Despite the proposed converter presents higher capacitive losses, when operating at 200 kHz, it has reduced volume of magnetics, resulting in an efficiency of 95.71%. If the proposed converter is designed for the operation at 80 kHz, a similar magnetic volume results when compared with the two-stage solution, but with a higher efficiency of 96.36% and avoiding the volume of resonant capacitors.