In this paper, we experimentally validate a tiled-aperture conformal projection system with the largest array filling factor and element beam truncation factor to the best of our knowledge. The conformal projection system, which is made up of a hexagonal adaptive fiber-optics collimator (AFOC) array with the proximate ideal intensity distributions, is fabricated and the performance of output beam is tested and evaluated properly and carefully. Both of the active phase-locking control and precise tip-tilt control are implemented successfully in the CBC of the hexagonal seven-beam-array. Experimental results show a large energy proportion (47%, which increases by over 10% comparing with the previously demonstrated largest value) in the central lobe is achieved and the residual phase error is lower than λ/27. When the AFOC array performs, the precise tilt control makes the combining beams overlap well and the average normalized metric value is improved from 0.336 without control to 0.947 with both of active piston and tip-tilt phase controls while the fringe contrast increases from 19% to more than 91% correspondingly. This work presents a promising structure for the achievement of large energy proportion in the central lobe in high power fiber laser CBC systems.
In this manuscript, we experimentally validate a novel design of adaptive fiber-optics collimator (AFOC), which utilizes two levers to enlarge the movable range of the fiber end cap. The enlargement of the range makes the new AFOC possible to compensate the end-cap/tilt aberration in fiber laser beam combining system. The new AFOC based on flexible hinges and levers was fabricated and the performance of the new AFOC was tested carefully, including its control range, frequency response and control accuracy. Coherent beam combination (CBC) of two 5-W fiber amplifiers array with simultaneously end-cap/tilt control and phase-locking control was implemented successfully with the novel AFOC. Experimental results show that the average normalized power in the bucket (PIB) value increases from 0.311 to 0.934 with active phasing and tilt aberration compensation simultaneously, and with both controls on, the fringe contrast improves to more than 82% from 0% for the case with both control off. This work presents a promising structure for tilt aberration control in high power CBC system.
The propagation properties of a radial Gaussian beam array through oceanic turbulence are studied analytically. The analytical expressions for the average intensity and the beam quality (power-in-the-bucket (PIB) and M2 -factor) of a radial beam array in a turbulent ocean are derived based on an account of statistical optics methods, the extended Huygens-Fresnel principle, and the second order moments of the Wigner distribution function. The influences of w , ε , and χT on the average intensity are investigated. The array divergence increases and the laser beam spreads as the salinity-induced dominant, ε decreased, and χT increased. Further, the analytical expression of PIB and the M2 -factor in the target plane is obtained. The changes of PIB and the M2 -factor with three oceanic turbulence parameters indicate that the stronger turbulence with a larger w , smaller ε , and larger χT results in the value of PIB decreasing, the value of the M2 -factor increasing, and the beam quality degrading.
We report on the development of a monolithic adaptive fiber optics collimator, with a large deflection angle and preserved near-diffraction-limited beam quality, that has been tested at a maximal output power at the 300 W level. Additionally, a new measurement method of beam quality ( factor) is developed. Experimental results show that the deflection angle of the collimated beam is in the range of 0–0.27 mrad in the direction and 0–0.19 mrad in the direction. The effective working frequency of the device is about 710 Hz. By employing the new measurement method of the factor, we calculate that the beam quality is and , which is in agreement with the result from the beam propagation analyzer and is preserved well with the increasing output power.
We present a new method of SBS suppression in fiber amplifier system by employing simultaneously phase and intensity modulation. In this way, a GHz narrow-linewidth polarization-maintaining (PM) all-fiber pulsed laser is obtained based on a master oscillator power amplifier (MOPA) configuration. The pulsed seed is generated from a single-frequency continuous wave (CW) laser at 1064 nm by simultaneous modulation using an electro-optic intensity modulator (EOIM) and an electro-optic phase modulator (EOPM). Theoretical model is built and simulation framework has been established to estimate the SBS threshold of the pulsed amplifier system before and after modulation. In experiment, in order to suppress SBS effectively, the pulse width is set to be 4 ns and the phase modulation voltage is set to be 5 V. After amplifying by the amplifier chain, a ~3.5 ns pulsed laser with average/peak power of 293 W/3.9 kW is obtained at intensity repetition rate of 20 MHz and phase repetition rate of 100MHz, showing good agreement with simulation results. The linewidth of the output laser is ~4.5 GHz, the M2 factor at maximal output power is measured to be ~1.1 and the slope efficiency is ~86%.This method provides some references to suppress the SBS in narrow linewidth pulsed amplifier systems.
Coherent beam combination (CBC) of fiber laser array, which is a promising approach to overcome the power scaling limitations of the single fiber laser and to achieve high-brightness laser with good beam quality, can be employed in coherent conformal projection system (CCPS) for beam projection and free space laser communication system with enormous potential. To date, all the demonstrated CBC system through several kilometers atmospheric turbulence have employed collimated beams, which significantly decrease the final CBC effect because of the inefficient wavefront overlap. On the other hand, focused CCPS has lots of advantages over collimated projection system since the wave front of the projected beam is closer to that of a convergent spherical wave. In this paper, we design and manufacture focused CCPS based on an adaptive fiber optics collimator array for the first time, which is achieved by introducing controllable spherical aberration through the adaptive fiber optics collimator. A CBC system is setup to evaluate and validate its performance. Results show that compared with the collimated CCPS, the energy portion of the central lobe could be increased by a factor of 44%, which agrees well with the theoretical analysis.