A novel robust terminal sliding‐mode control (RTSMC) based on radial basis function (RBF) neural network is proposed firstly for controlling the attitude and position of the quadrotor, guaranteeing the system converged to stability point in a limited time. After establishing the nonlinear kinematics and dynamics models of the system, robust control is adopted in the RBF neural network terminal sliding‐mode controller such that the impact of external interference is reduced effectively. Resorting to the Lyapunov function, the asymptotically stable condition for the considered system is obtained, in which the convergence of the system is deduced in a finite time. Furthermore, simulation results are given to show the faster convergence speed and strong robustness for the considered system with RBF and RTSMC. Finally, the effectiveness and robustness of the developed control strategy is validated experimentally.
15 April 2024 in International Journal of Robust and Nonlinear Control
The corrosion assessment of reinforced concrete is an important problem. Most of the current detection methods are to perform corrosion evaluation on a single corrosion feature. The evaluation result depends on expert experience and existing prior knowledge information. In this paper, a neural network model based on improved quantum particle swarms optimisation (QPSO-NN) is proposed, which uses quantum particle swarms to optimise neural network (NN) weights and thresholds to predict the corrosion degree of reinforced concrete. The improved QPSO optimise the adjustment strategy of the Mean Best Position weight and improves the convergence speed of particles. The Simulated annealing algorithm (SA) is introduced in the iterative process of the particles to enhance the global optimisation capability of the particles. Under a variety of environmental parameters(pH, water/cement ratio, Chloride concentration), a variety of corrosion characteristic data are detected through the designed embedded acquisition system. The improved QPSO-NN corrosion model algorithm has better convergence speed by simulated analysis and has better accuracy of reinforcement corrosion assessment by experimental.
Rebar corrosion is one of the main reasons for the deterioration of concrete structures. In order to ensure the safe operation of reinforced concrete structures, it is necessary to detect the corrosion rate of rebars in time. This article adopts the eddy current method based on electromagnetic induction to detect steel corrosion, studies the mechanism of alternating current (AC) impedance change induced by steel corrosion in coils, and establishes a mathematical model between steel corrosion and coil AC impedance. Meanwhile, the quantitative relationship between excitation signal frequency, concrete thickness, coil parameters, and coil impedance is studied. Through experiments, it was found that in the early stages of steel corrosion, there is a linear relationship between the scanning peak value of the coil impedance and the mass loss rate of the steel bars, and the slope of the fitting curve decays exponentially with the increase of the concrete thickness. The method used in this paper has an absolute error of less than 0.01 and a relative error of less than 8 % in detecting the mass loss rate of rebars at the initial stage of steel corrosion. When the concrete thickness is less than 20 mm, the relative error is lower than 4 %.
The synchronization of fractional-order chaotic systems (FOCSs) plays an important role in modern control theory, the projective synchronization (PS) as a class of synchronization problems, also has huge applications and has attracted much attention. It is, however, shown in the obtained literature that the results on the PS of FOCSs either loss the rigorous theoretical demonstration or verify from the viewpoint of numerical simulations. How to derive a necessary and sufficient condition to guarantee the PS of complex FOCSs by a simple controller is still open. To this end, this article is concerned with the PS of fractional-order unified systems (FO-USs) that are important in FOCSs covering fractional-order Lorenz, Chen and Lü systems, where the controller is presented based on the lower triangular structure by use of the back-stepping technique. The necessary and sufficient criterion for the PS of FO-USs is proposed by solving an algebraic equation, and the controller for the PS of FO-USs is derived based on the lower triangular structure combined with back-stepping approach. Finally, the simulation results are reported to verify the correctness and efficiency of the obtained results.