The analysis of chemical species is one of the most fundamental and long-standing challenges in fiber-optic sensors research. Existing sensor architectures require a spatial overlap between light and the substance being tested and rely either on structural modifications of standard fibers or on specialty photonic crystal fibers. In this work, we report an optomechanical fiber sensor that addresses liquids outside the cladding of standard, 8/125 μm single-mode fibers with no structural intervention. Measurements are based on forward stimulated Brillouin scattering by radial, guided acoustic modes of the fiber structure. The acoustic modes are stimulated by an optical pump pulse and probed by an optical signal wave, both confined to the core. The acoustic vibrations induce a nonreciprocal phase delay to the signal wave, which is monitored in a Sagnac interferometer loop configuration. The measured resonance frequencies and excitation strengths of individual modes agree with the predictions of a corresponding quantitative analysis. The acoustic reflectivity at the outer cladding boundary and the acoustic impedance of the surrounding medium are extracted from cavity lifetime measurements of multiple modes. The acoustic impedances of deionized water and ethanol are measured with better than 1% accuracy. The measurements successfully distinguish between aqueous solutions with 0, 4%, 8%, and 12% concentrations of dissolved salt. The new fiber-sensing paradigm might be used in the monitoring of industrial processes involving ionic solutions.

Optical sensing offers an attractive solution to the societal concern for prevention of natural and human‐generated threats and for efficient use of natural resources. The unprecedented properties of optical fibers make them ideal for implementing a ‘nervous system’ in structural health monitoring: they are small, low‐cost and electrically and chemically inert. In particular, the nonlinear interaction of stimulated Brillouin scattering allows for the distributed measurement of strain and temperature with tens of km range. In this work, a novel, radar‐inspired technique for random‐access Brillouin scattering‐based sensors is shown, making a significant step towards a real optical sensing nerve. The method selectively addresses each fiber segment as a distinct sensing element in a synaptic neuronal system. The measurement principle relies on phase‐coding of both the Brillouin pump and signal waves by a high‐rate, pseudo‐random bit sequence. Temperature measurements with 1 cm resolution are reported. The measurement range is scalable to several km.

The exotic physics emerging in non-Hermitian systems with balanced distributions of gain and loss has recently drawn a great deal of attention. These systems exhibit phase transitions and exceptional point singularities in their spectra, at which eigen-values and eigen-modes coalesce and the overall dimensionality is reduced. So far, these principles have been implemented at the expense of precise fabrication and tuning requirements, involving tailored nano-structured devices with controlled optical gain and loss. In this work, anti-parity-time symmetric phase transitions and exceptional point singularities are demonstrated in a single strand of single-mode telecommunication fibre, using a setup consisting of off-the-shelf components. Two propagating signals are amplified and coupled through stimulated Brillouin scattering, enabling exquisite control over the interaction-governing non-Hermitian parameters. Singular response to small-scale variations and topological features arising around the exceptional point are experimentally demonstrated with large precision, enabling robustly enhanced response to changes in Brillouin frequency shift.

Optical fibres constitute an exceptional sensing platform. However, standard fibres present an inherent sensing challenge: they confine light to an inner core. Consequently, distributed fibre sensors are restricted to the measurement of conditions that prevail within the core. This work presents distributed analysis of media outside unmodified, standard fibre. Measurements are based on stimulated scattering by guided acoustic modes, which allow us to listen where we cannot look. The protocol overcomes a major difficulty: guided acoustic waves induce forward scattering, which cannot be mapped using time-of-flight. The solution relies on mapping the Rayleigh backscatter contributions of two optical tones, which are coupled by the acoustic wave. Analysis is demonstrated over 3 km of fibre with 100 m resolution. Measurements distinguish between air, ethanol and water outside the cladding, and between air and water outside polyimide-coated fibres. The results establish a new sensor configuration: optomechanical time-domain reflectometry, with several potential applications.

Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.

Opto-mechanical interactions in planar photonic integrated circuits draw great interest in basic research and applications. However, opto-mechanics is practically absent in the most technologically significant photonics platform: silicon on insulator. Previous demonstrations required the under-etching and suspension of silicon structures. Here we present surface acoustic wave-photonic devices in silicon on insulator, up to 8 GHz frequency. Surface waves are launched through absorption of modulated pump light in metallic gratings and thermo-elastic expansion. The surface waves are detected through photo-elastic modulation of an optical probe in standard race-track resonators. Devices do not involve piezo-electric actuation, suspension of waveguides or hybrid material integration. Wavelength conversion of incident microwave signals and acoustic true time delays up to 40 ns are demonstrated on-chip. Lastly, discrete-time microwave-photonic filters with up to six taps and 20 MHz-wide passbands are realized using acoustic delays. The concept is suitable for integrated microwave-photonics signal processing.