When a living tissue is subjected to cyclic stretching, the stress-strain curves show a shift down with the increase in the number of cycles until stabilization. This phenomenon is referred to in the literature as a preconditioning and is performed to obtain repeatable and predictable measurements. Preconditioning has been routinely performed in skin tissue tests; however, its effects on the mechanical properties of the material such as viscoelastic response, tangent modulus, sensitivity to strain rate, the stress relaxation rate, etc….remain unclear. In addition, various physical interpretations of this phenomenon have been proposed and there is no general agreement on its origin at the microscopic or mesoscopic scales. The purpose of this study was to investigate the effect of the cyclical stretching and the stress-relaxation tests on the mechanical properties of the porcine skin. Cyclic uniaxial tensile tests at large and constant strain were performed on different skin samples. The change in the reaction force, and skin's tangent modulus as a function of the number of cycles, as well as the strain rate effect on the mechanical behavior of skin samples after cycling were investigated. Stress-relaxation tests were also performed on skin samples. The change in the reaction force as a function of relaxation time and the strain rate effect on the mechanical behavior of skin samples after the stress-relaxation were investigated. The mechanical behavior of a skin sample under stress-relaxation test was modeled using a combination of hyperelasticity and viscoelasticity. Overall, the results showed that the mechanical behavior of the skin was strongly influenced by cycling and stress relaxation tests. Indeed, it was observed that the skin's resistance decreased by about half for two hours of cycling; the tangent modulus degraded by nearly 30% and skin samples became insensitive to the strain rates and accumulated progressively an inelastic deformation over time during cycling. Finally, the hysteresis loops became very narrow at the end of cycling and after relaxation process.

One way to characterize metallic materials in the presence of defects like dislocation networks is to measure their large dynamic nonlinear elastic response. In this numerical study, a new method combining the nonlinear elastic wave spectroscopy (NEWS) method with a time reversal (TR) process is proposed. This method, called NEWS-TR, uses nonlinear analysis as a pretreatment of time reversal and then consists of retrofocusing only nonlinear components on the defect position. A two-dimensional pseudospectral time domain algorithm is developed here to validate the NEWS-TR method as a potential technique for damage location. Hysteretic nonlinear behavior of the materials being studied is introduced using the Preisach-Mayergoyz model. Moreover, in order to extend this solver in two dimensions, the Kelvin notation is used to modify the elastic coefficient tensor. Simulations performed on a metallic sample show the feasibility and value of the NEWS-TR methodology for microdamage imaging. Retrofocusing quality depends on different parameters such as the filtering method used to keep only nonlinear components and the nonlinear effect measured. In harmonic generation, pulse inversion filtering seems to be a more appropriate filtering method than classical harmonic filtering for most defect positions, mainly because of its ability to filter all fundamental components.