Ming Lü

Dr. Ming Lü


Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 November 2017 in Meccanica
Verified
Journal Article
Closed access
PDF file
XWXin-Tao Wang
Xin-Tao Wang
ZNZhi Ning
Zhi Ning
MLMing Lü
Ming Lü
CSChun-Hua Sun
Chun-Hua Sun

19 December 2015 in Meccanica
Verified
Journal Article
Closed access
PDF file
MLMing Lü
Ming Lü
ZNZhi Ning
Zhi Ning
KYKai Yan
Kai Yan
JFJuan Fu
Juan Fu
CSChunhua Sun
Chunhua Sun

10 December 2019 in Processes
Verified
Journal Article
Open access
PDF file
SLShuang-Xi Liu
Shuang-Xi Liu
MLMing Lü
Ming Lü
Diesel particulate filter is one of the most effective after-treatment techniques to reduce Particulate Matters (PM) emissions from a diesel engine, but the blocking Diesel Particulate Filter (DPF) will seriously affect the engine performance, so it is necessary to study the fault diagnosis of blocking DPF. In this paper, a simulation model of an R425DOHC diesel engine with wall-flow ceramic DPF was established, and then the model was verified with experimental data. On this basis, the fault diagnosis of the blocking DPF was studied by using spectral analysis on instantaneous exhaust pressure. The results showed that both the pre-DPF mean exhaust pressure and the characteristic frequency amplitude of instantaneous exhaust pressure can be used as characteristic parameters of monitoring the blockage fault of DPF, but it is difficult to monitor DPF blockage directly by instantaneous exhaust pressure. In terms of sensitivity, the characteristic frequency amplitude of instantaneous exhaust pressure is more suitable as a characteristic parameter to monitor DPF blockage than mean exhaust pressure. This work can lay an important theoretical foundation for the on-board diagnosis of DPF.

6 July 2021 in Applied Sciences
Verified
Journal Article
Open access
PDF file
JZJin Zhao
Jin Zhao
ZNZhi Ning
Zhi Ning
MLMing Lü
Ming Lü
CSChunhua Sun
Chunhua Sun
The application prospect of a flow focusing/blurring nozzle is broad but research on gas-liquid flow inside the nozzle is not comprehensive. The gas-liquid mixing inside the nozzle is difficult to study by visualization experiment, so this paper proposes to study the gas-liquid flow or mixing inside the nozzle by the gray scale level distribution of the experimental images. The results show that the increase of air flow rate is beneficial to two-phase mixing inside the nozzle, while the influence of water flow rate, tube hole distance (the distance between inner tube and nozzle outlet) and orifice diameter increase is opposite. The influence of air inertia force on two-phase mixing is weaker than the water inertia force under different parameters, the effect of the air inertia force on two-phase mixing is similar to tube hole distance under a small flow rate, the effect of the orifice diameter on two-phase mixing is relatively weak. In addition, the analysis of the gas-liquid flow field in the mixing zone shows that the gas-liquid flow in the nozzle is stable in the flow focusing mode. In the flow blurring mode, the gas-liquid flow inside the nozzle has radial stability but axial pulsation. In the transition mode, the gas-liquid flow inside the nozzle is unstable, but the gas-liquid flow is close to the flow blurring mode.

1 September 2018 in AIAA Journal
Verified
Journal Article
Closed access
XWXin-Tao Wang
Xin-Tao Wang
ZNZhi Ning
Zhi Ning
MLMing Lü
Ming Lü
A new theoretical model is established to study the breakup of a charged power-law liquid jet, which is moving in coaxial swirling air. The liquid non-Newtonian behavior is explained by the power-law model, which is assumed to be the leaky dielectric material in this paper. The corresponding dispersion relation about the radical electrical field is derived by linear analysis. Results show that when the air swirl is introduced, the changing trend of the unstable growth rate on the axisymmetric mode is the same as the nonaxisymmetric ones. It is noted that the air swirl is one of the factors that stabilize the power-law liquid jet. Moreover, the effects of the electric field and the Weber number on the jet instability are examined on the temporal mode. Especially, when the electrostatic force increases to a threshold value, the effect of the air swirl is almost negligible on the jet breakup. Finally, the difference can be revealed between the Newtonian and the non-Newtonian liquid jets by investigating the effect of the power-law index.

18 January 2024 in Entropy
Verified
Journal Article
Open access
PDF file
XLXiaoYu Li
XiaoYu Li
ZNZhi Ning
Zhi Ning
MLMing Lü
Ming Lü
In this work, a lattice Boltzmann method (LBM) for studying microchannel gas flow is developed in the multi-flow regime. In the LBM, by comparing previous studies’ results on effective viscosity in multi-flow regimes, the values of the rarefaction factor applicable to multi-flow regions were determined, and the relationship between relaxation time and Kn number with the rarefaction factor is given. The Kn number is introduced into the second-order slip boundary condition together with the combined bounce-back/specular-reflection (CBBSR) scheme to capture the gas flow in the multi-flow regime. Sensitivity analysis of the dimensionless flow rate to adjustable parameters using the Taguchi method was carried out, and the values of adjustable parameters were determined based on the results of the sensitivity analysis. The results show that the dimensionless flow rate is more sensitive to j than h. Numerical simulations of Poiseuille flow and pulsating flow in a microchannel with second-order slip boundary conditions are carried out to validate the method. The results show that the velocity profile and dimensionless flow rate simulated by the present numerical simulation method in this work are found in the multi-flow regime, and the phenomenon of annular velocity profile in the microchannel is reflected in the phases.