The chemical structure and morphology of a set of sulfonic gel-type poly(styrene-divinylbenzene) resins (2 mol% DVB) prepared with different synthetic approaches were investigated by solid state NMR, Inverse Size Exclusion Chromatography (ISEC), FT-IR and elemental analysis to compare their swollen state structure. FT-IR and solid state NMR clearly show that the sulfonation mainly occurs in the para- position with respect the main polymer chain. Sensible proportions of sulfone bridges were found in the materials obtained with oleum and chlorosulfonic acid. With oleum, the presence of the sulfone bridges is clearly associated to a reduced ability to swell in the water medium relative to the proton exchange capacity. This highlights the cross-linking action of the sulfone bridges according to ISEC results, showing a high proportion of a dense polymer fraction in the swollen material. An even higher degree of sulfone-bridging, lower swelling ability, and a high proportion of a dense polymer fraction in the swollen material are found in the resin obtained with chlorosulfonic acid. As a matter of fact, Cross Polarization Magic Angle Spinning Nuclear Magnetic Resonance (CP-MAS 13C-NMR), elemental analysis, and ion exchange capacity, show that oleum and chlorosulfonic acid produced resins with remarkably smaller pores and lower swollen gel volume in polar solvents, with respect to concentrated sulfuric acid.
The direct synthesis of hydrogen peroxide has been for about 20 years a hot topic in “green” catalysis. Several methods, which are well established to measure the concentration of hydrogen peroxide in water are also applied to the analysis of reaction mixtures from the direct synthesis of H2O2. However, this step could not be always straightforward, because these mixtures contain almost invariably organic solvents and, sometimes, selectivity enhancers which can interfere in some, at the least, of the most popular titrimetric methods. This work presents a comparative investigation of iodometry, cerimetry, permanganometry (titrimetric methods) and spectrophotometric analysis of TiIV/H2O2 adduct, as applied to analysis of hydrogen peroxide produced by its direct synthesis. They account for more than 90 % of the competent literature since 2000. Their pros and cons are highlighted to provide a guideline for the choice of the best possible method of analysis and for the comparison of catalytic results assessed in different ways in the context of the direct synthesis of hydrogen peroxide.
Several sulfonated cross-linked copolymers functionalized with hydroxyl and carboxylic groups have been synthesized. The amount of the cross-linking monomer was tailored (from 4% up to 40%) to tune the resulting micro- and nano-morphologies, and two types of catalysts, namely, gel-type and macroreticular catalysts, were obtained. These copolymers were employed in the catalytic hydrolysis of wheat straw pretreated in 1-ethyl-3-methylimidazolium acetate to obtain sugars. Remarkably, the presence of additional oxygenated groups enhances the catalytic performances of the polymers by favoring the adsorption of β-(1,4)-glucans and makes these materials significantly more active than an acidic resin bearing only sulfonic groups (i.e., Amberlyst 70). In addition, the structure of the catalyst (gel-type or macroreticular) appears to be a determining factor in the catalytic process. The gel-type structure provides higher glucose concentrations because the morphology in the swollen state is more favorable in terms of the accessibility of the catalytic centers. The observed catalytic behavior suggests that the substrate diffuses within the swollen polymer matrix and indirectly confirms that the pretreatment based on dissolution/precipitation in ionic liquids yields a substantial enhancement of the conversion of lignocellulosic biomass to glucose in the presence of heterogeneous catalysts.