This work presents experimental results on the synthesis of сarbon nanowalls (CNWs) with predefined morphology on the surface of the nanoporous alumina membrane using two different methods, namely radio-frequency plasma-enhanced chemical vapor deposition (RF-PECVD) and radical-injection (RI)-PECVD. Obtained samples were characterized by the methods of scanning electron microscopy (SEM), transmission electron microscopy (TEM), and Raman spectroscopy. From the microstructure analyses of CNWs, it has been observed that there is a time dependence on the reproducibility of membrane morphology by CNWs. At the early stage of nanowalls growth, nanowalls prefer to grow around the edges of nanopores and continue to grow vertically with time. In RF-PECVD, the nanopores’ size begins to shrink drastically and pores are completely covered by secondary flake-like nanowalls after 25 minutes of growth. In the case of CNWs grown using RI-PECVD, nanowalls are more vertical and self-supported. This is because of the rapid and sustained production of hydrogen radicals that prevent the secondary growth of carbon nanowalls. In addition, the influence of pores diameter and membrane thickness on the growth of RI-PECVD CNWs was revealed.
Nanoporous aluminum oxide membranes (NPAOM), obtained by a two-stage anodizing process, was an ideal material for creating nanostructures on its basis with given structural parameters and properties. NPAOM were used to create polymer nanostructures, non-interwoven carbon nanotubes, nanorods and nanowires of various materials, such as metals, oxides, etc. due to the structural features and physicochemical properties of NAOM, such as high chemical resistance, which increases with annealing temperature. Atomic Force Microscopy has been used as an ideal method for studying structural features of aluminum oxide nanoporous membranes as dielectric material with unique properties.
Optical microscopy is currently one of the widely used methods used to study micro- and nanostructured materials. Despite the fact that optical microscopy is inferior in resolving power to atomic force and scanning electron microscopy, in most cases this method makes it possible to efficiently investigate various structures. Nanofibers based on nanoporous alumina are of interest as a hydrophobic surface. Therefore, the study of its structural features is a promising research work.
Process of obtaining one-layer porous alumina etching mode in a strong field was investigated. Morphology of samples was determined at various stages of anodizing. Ordered arrangement of pores, nanowires and nanorods of aluminum oxide were shown within the one etching step.